Hydroprocessing of biomass feedstock over sulfided CoMo-, NiMo-, and NiW-supported catalysts for bio-jet fuel component production: a review

Marina V. Bukhtiyarova,Evgenia N. Vlasova,Galina A. Bukhtiyarova
DOI: https://doi.org/10.1039/d4se00302k
IF: 6.813
2024-07-13
Sustainable Energy & Fuels
Abstract:Recently, bio-jet fuels have attracted significant attention as a prospective additive to conventional aviation fuels since this is the most promising strategy to reduce CO 2 emissions in the aviation sector in the future. Bio-jet fuels can be produced via the hydroprocessing of vegetable oils containing long-chain triglycerides. This study presents a review of the recent literature on the catalytic properties of sulfided CoMo-, NiMo- and NiW-supported materials in the hydroprocessing of oils under different reaction conditions. The comparison of CoMo and NiMo/Al 2 O 3 catalysts showed that CoMo catalysts can produce jet fuel hydrocarbons C 8 –C 16 with low yields of 5.0–17.5%, which are insufficient for commercial use. Alternatively, the use of NiMo/Al 2 O 3 catalysts increased the yields of jet fuel achieved via hydroprocessing a mixture of vegetable oils with gas oil/kerosene or hydroprocessing vegetable oil with a high content of C 10 –C 14 fatty acids. In addition, the modification of zeolites (ZSM-5, USY) promoted the formation of suitable mesoporosity and acidity in support for the inhibition of deep cracking of C 9 –C 18 hydrocarbons, resulting in high yields of bio-jet components in the range of 30–75%. The i / n ratio was more than 2.0, which promoted the formation of bio-jet fuel with a low freezing point, meeting the regulation of ASTM standards. In contrast, NiW-containing catalysts have been scarcely studied for the hydroconversion of vegetable oils for jet fuel production due to the high price of W precursors and complex transformation of the oxidic precursor of tungsten to the active sulfided state. A continuous pilot plant experiment showed that the Ni–W/SiO 2 –Al 2 O 3 catalyst could stably function for 100 hours without loss in the yield of bio-jet components (30%).
materials science, multidisciplinary,chemistry, physical,energy & fuels
What problem does this paper attempt to address?