Abstract:Ultra-high heat flux (up to 1000 W/cm2) thermal management has been an urgent need for advanced power electronic devices to maintain their superior electrical performance and reliability. Embedded microchannel cooling is a promising and challenging thermal management method for high-heat-flux chips. This study presents an embedded Z-type manifold microchannel (Z-MMC) cooling design for a 5 x 5 mm2 heating zone, which can dissipate an ultra-high heat flux up to 1842 W/cm2 by using water single-phase flow. The microchannel array is etched on silicon wafer, while the manifold structure is fabricated by PDMS molding. The test chips are assembled using O2 plasma bonding technique, which provides an observation window for visualizing the flowing state of the coolant during the heat transfer process. We experimentally test and compare four test chips with different microchannel geometries and manifold designs. The average heater temperature, temperature distribution, thermal resistance, heat transfer coefficient and pressure drop are reported for mass flow rates of 2-6 g/s. The proposed Z-MMC cooler is capable of dissipating up to 1800 W/cm2 with a total thermal resistance of only 0.075 cm2 center dot K/W (only 0.039 cm2 center dot K/W after subtracting the conduction thermal resistance), at a flow rate of 6 g/s and a pressure drop of 54 kPa. Compared to the rectangular manifold arrangement, the trapezoidal manifold demonstrates a lower temperature rise, a more uniform temperature distribution and a smaller pressure drop at the same heat flux and flow rate, mainly due to a more uniform fluid distribution in the microchannel. Furthermore, we compare our proposed design's thermo-hydraulic performance with those of representative manifold microchannel cooling data in the literature, and the proposed Z-MMC design demonstrates relatively low thermal resistance and pressure drop values.

Unidirectional heat and fluid transfer performances of thermal diode with fishbone-microstructure wicks

Unidirectional Heat and Fluid Transfer Performances of a Thermal Diode with Fishbone-Microstructure Wicks

Design and Experimental Analysis of a Novel Thermal Diode with Asymmetric Heat Transfer Inspired by Feather

Numerical Study on Hybrid Discontinuous Microchannel Heat Sink Combining Manifold with Pin Fins (DMC-MPF) for High Power Electronic Device

Effect of Direct Liquid Cooling Technology With Flow Guide Integration on Avionics Devices Thermal and Electrical Performance

High performance heat sink with counter flow diverging microchannels

Experimental Study of an Aluminum Based Three-Dimensional Thermosyphon Heat Sink with Microscale Enhancement Structure

Jet Microchannel with Sawtooth Wall for Efficient Cooling of High-Power Electronics

An Immersed Jet Array Impingement Cooling Device with Distributed Returns for Direct Body Liquid Cooling of High Power Electronics

Simulations on the effective thermal dissipation of the microchannel heat sink with different pin fins

Embedded heat pipe SiC interposer for distributed power devices

Bidirectional interlayer cooling of 3D chip stack for temperature uniformity enhancement and hotspot mitigation

Experimental and numerical study of structural parameters on the heat transfer performance of submerged cooling system

Efficient Thermal Management of High-Power Electronics Via Jet-Enhanced HU-type Manifold Microchannel

Extremely high heat flux dissipation and hotspots removal with nature-inspired single-phase microchannel heat sink designs

Thermal management of electronic components based on new wave bio-inspired structures and nanofluids

A High Efficient Integrated Heat Dissipation Systems with CNT Array Based Heat Lines and Microchannel Heat Sink in 3D ICs

Applications of Microfluidic Devices for Electronics Thermal Management

Investigation of Z-type Manifold Microchannel Cooling for Ultra-High Heat Flux Dissipation in Power Electronic Devices

Two-Phase Liquid Cooling for High-Power Microelectronics via Embedded Micro-Pin Fin Heat Sink

Electrically driven chip cooling device using hybrid coolants of liquid metal and aqueous solution