Abstract:The induced impacts of high doses of gamma irradiation on the structural variations of poly-allyl-diglycol carbonate (PADC) polymers (CR-39) were studied in terms of X-ray diffraction (XRD) patterns. CR-39 samples were irradiated separately at different ranging from 200 to 800 kGy; (step 200). A deconvolution process of the XRD spectra of CR-39 samples for all gamma irradiation doses was performed. The results of this deconvolution process for the pristine specimen show three diffraction peaks at about 20.30°, 28.16° and 41.70° of 2 θ . The broad peaks at 28.16 o and 41.70°, and the highest peak at 20.30° of XRD confirm the amorphous nature and low degrees of crystallinity, respectively. The position, area, intensity and full width at half maximum of these peaks are changed with further doses of gamma irradiation. With additional gamma irradiations, the intensities of all peaks decrease significantly. The highest and sharpest peak properties are employed to determine the crystallinity, crystallite size, and radiation chemical yield (G-value) for the loss of carbonate ester bonds using a proposed method. Higher doses of gamma irradiation result in a decrease in crystallinity while increasing crystallite size. Furthermore, the optical band gaps reduced from 4.81 to 3.49 eV when the irradiated dose increased from 0 to 800 kGy. Furthermore, the third order nonlinear susceptibility increased from 0.84x10 −12 esu to 2.25x10 −12 esu with increasing the radiation doses from 0 to 800 kGy. Moreover, the nonlinear refractive increased from 1.52x10 −11 to 3.69x10 −11 with increasing the radiation doses from 0 to 800 kGy. On the other hand, the number of carbon atoms in each cluster increased from 51 to 97 when the irradiated dose increased from 0 kGy to 800 kGy.

Chemical damage around Xe ion tracks in Poly(allyl diglycol carbonate) PADC track detector

Surface Effect of Ultraviolet Radiation on Electrochemically Etched Alpha-Particle Tracks in PADC

Direct and indirect determination of track etch parameters after sequential UV-C exposure and etching for two swift heavy ions in PADC: Production of rocket-shaped tracks

Studies on Surface Damage Induced by Ion Bombardment

Changes in the hydrophilicity of the surface of PADC under ionizing radiations: Anomalous increase of the contact angle of water droplets under protons

Development of A New Approach to Simulate A Particle Track under Electrochemical Etching in Polymeric Detectors

Influence of UV-Irradiation on Latent Tracks in Polyethylene Terephthalate Films

Mitigating the effects of charged particle strikes on TES arrays for exotic atom X-ray experiments

Effects of track overlapping on ion-track grafting reactivity

Efficient Preparation of Poly(allyl diglycol carbonate) (PADC) Nuclear Track Detectors: UV Photopolymerization

SAXS Investigation of Latent Track Structure in HDPE Irradiated with High Energy Fe Ions

Atomic-Scale Insights into Damage Produced by Swift Heavy Ions in Polyethylene

Spectroscopic and electrical changes in Lr-115 type II nuclear track detector before and after gamma radiation

Quantitative Analysis of Electron Beam Damage in Organic Thin Films

Verification of Mason and Smythe equations for electrical treeing breakdown at the tip of charged particle tracks in ECE polycarbonate detectors

Mass spectrometric study of low energy Cs+ ion‐induced sputtered fragmentation of PADC polymer

Studies of chemical bonds loss and optical modifications of CR-39 caused by gamma rays

Charge transport behavior in gamma‐ray irradiated poly(ethylene terephthalate) estimated by surface potential decay

Insight into What Is inside Swift Heavy Ion Latent Tracks in PET Film

Energy Calibration of a CR-39 Nuclear-Track Detector Irradiated by Charged Particles

Direct characterization of ion implanted nanopore pyrolytic graphite coatings for molten salt nuclear reactors