Development of A New Approach to Simulate A Particle Track under Electrochemical Etching in Polymeric Detectors

Ali Mostofizadeh,Yudong Huang,M. Reza Kardan,Asad Babakhani,Xiudong Sun

DOI: https://doi.org/10.1016/j.radmeas.2011.10.019

IF: 1.743

2012-01-01

Radiation Measurements

Abstract:A numerical approach based on image processing was developed to simulate a particle track in a typical polymeric detector, e.g., polycarbonate, under electrochemical etching. The physical parameters such as applied voltage, detector thickness, track length, the radii of curvature at the tip of track, and the incidence angle of the particle were considered, and then the boundary condition of the problem was defined. A numerical method was developed to solve Laplace equation, and then the distribution of the applied voltage was obtained through the polymer volume. Subsequently, the electric field strengths in the detector elements were computed. In each step of the computation, an image processing technique was applied to convert the computed values to grayscale images. The results showed that a numerical solution to Laplace equation is dedicatedly an attractive approach to provide us the accurate values of electric field strength through the polymeric detector volume as well as the track area. According to the results, for a particular condition of the detector thickness equal to 445 mu m, track length of 21 mu m, the radii of 2.5 mu m at track tip, the incidence angle of 90 degrees, and the applied voltage of 2080 V, after computing Laplace equation for an extremely high population of 4000 x 4000 elements of detector, the average field strength at the tip of track was computed equal to 0.31 MV cm(-1) which is in the range of dielectric strength for polymers. The results by our computation confirm Smythe's model for estimating the ECE-tracks. (c) 2011 Elsevier Ltd. All rights reserved.