Abstract:This part of the paper presents the current experimental flow boiling heat transfer and CHF data acquired for R134a, R236fa and R245fa in single, horizontal channels of 1.03, 2.20 and 3.04mm diameters over a range of experimental conditions. The aim of this study is to investigate the effects of channel confinement, heat flux, flow pattern, saturation temperature, subcooling and working fluid properties on the two-phase heat transfer and CHF. Experimentally, it was observed that the flow boiling heat transfer coefficients are a significant function of the type of two-phase flow pattern. Furthermore, the monotonically increasing heat transfer coefficients at higher vapor qualities, corresponding to annular flow, signifies convective boiling as the dominant heat transfer mechanism in these small scale channels. The decreasing heat transfer trend at low vapor qualities in the slug flow (coalescing bubble dominated regime) was indicative of thin film evaporation with intermittent dry patch formation and rewetting at these conditions. The coalescing bubble flow heat transfer data were well predicted by the three-zone model when setting the dryout thickness to the measured surface roughness, indicating for the first time a roughness effect on the flow boiling heat transfer coefficient in this regime. The CHF data acquired during the experimental campaign indicated the influence of saturation temperature, mass velocity, channel confinement and fluid properties on CHF but no influence of inlet subcooling for the conditions tested. When globally comparing the CHF values for R134a in the 0.51–3.04mm diameter channels, a peak in CHF peak was observed lying in between the 0.79 (Co≈0.99) and 1.03 (Co≈0.78)mm channels. A new CHF correlation has been proposed involving the confinement number, Co that is able to predict CHF for R134a, R236fa and R245fa in single-circular channels, rectangular multichannels and split flow rectangular multichannels. In summary, the present flow boiling and CHF trends point to a macro-to-microscale transition as indicated by the results presented in Ong and Thome (2011) [1].

Influence of rolling motion on CHF location during subcooled flow boiling through a mini-channel

Numerical Investigation of Subcooled Flow Boiling in an Inclined Rectangular Mini-Channel at a Low Flow Rate

Effects of two-phase inlet quality, mass velocity, flow orientation, and heating perimeter on flow boiling in a rectangular channel: Part 2 - CHF experimental results and model

Numerical investigation of critical heat flux during subcooled flow boiling in a vertical rectangular Mini-channel

Analysis of the critical heat flux of subcooled flow boiling in microgravity

Effects of Heat Flux, Mass Flux, Inlet Fluid Subcooling, and Channel Orientation on Subcooled Flow Boiling in a High-Aspect-Ratio Rectangular Microchannel

Numerical investigation of azimuthal heat conduction effects on CHF phenomenon in rod bundle channel

Study on CHF Characteristics in Narrow Rectangular Channel under Complex Motion Condition

Subcooled flow boiling on hydrophilic and super-hydrophilic surfaces in microchannel under different orientations

CFD simulation focusing on void distribution of subcooled flow boiling in circular tube under rolling condition

A Phenomenological Investigation on Near-Wall Bubble Behavior Close to Chf in Flow Boiling

THE EFFECT OF CHANNEL HEIGHT ON FLOW BOILING HEAT TRANSFER AND CHF IN FLAT MINICHANNELS WITH LOCAL HEATING

Experimental Study on Local Subcooled Flow Boiling Heat Transfer in A Vertical Mini-Gap Channel

Investigation of flow boiling critical heat flux and heat transfer within a horizontally oriented channel with one-sided heating at three levels of subcooled inlet

An Improved Liquid Film Model to Predict the CHF Based on the Influence of Churn Flow

Macro-to-microchannel transition in two-phase flow: Part 2 – Flow boiling heat transfer and critical heat flux

Investigation on visualization and heat transfer performance study of the mini-channel flow boiling

Local Heat Transfer in Subcooled Flow Boiling in a Vertical Mini-Gap Channel

Study on the CHF Correction Factor under Rolling Condition in Vertical Tube

Numerical simulation of boiling behavior in vertical microchannels

Experiment study of flow boiling heat transfer characteristics in horizontal rectangular channel