Optimized the Carrier Transport Path and Separation Efficiency of 2D/2D Heterojunction in Photoelectrochemical Water Splitting

Hongxia Qian,Zhifeng Liu,Bo Zhang,Junwei Li,Jing Ya
DOI: https://doi.org/10.1002/cctc.202001765
IF: 4.5
2021-02-16
ChemCatChem
Abstract:It is a promising strategy that the photoelectrode with high charge transfer rate and separation efficiency is designed in the photoelectrochemical (PEC) water splitting. Herein, the nanoflakes/nanoflakes (2D/2D) MoS 2 /ZnIn 2 S 4 heterojunction is synthesized by two‐step hydrothermal methods. The carrier transport path in heterojunction is optimized through the Schottky contact calculated by density functional theory (DFT) and large specific surface area between 2D nanoflakes MoS 2 and ZnIn 2 S 4 . Besides, the bimetallic oxyhydroxide NiFeOOH can be used as co‐catalyst to improve the separation of carriers. The results exhibit that MoS 2 /ZnIn 2 S 4 /NiFeOOH photoelectrode with dramatically enhanced photocurrent density of 0.74 mA/cm 2 at 1.23 V versus the reversible hydrogen electrode (V RHE ), which is 2.6 and 5.7 times higher than the bare MoS 2 and ZnIn 2 S 4 , respectively. And it has the largest charge separation efficiency (η bulk ) (22.8%) and charge transfer efficiency (η surface ) (64.6%) in the as‐prepared samples. This work provides a strategy for design of the photoelectrode with excellent charge transfer efficiency and separation efficiency in PEC water splitting.
chemistry, physical
What problem does this paper attempt to address?
The problem that this paper attempts to solve is how to improve the carrier transport efficiency and separation efficiency of photoanode materials in photoelectrochemical (PEC) water splitting. Specifically, by constructing a 2D/2D heterojunction (MoS₂/ZnIn₂S₄) and combining with the cocatalyst NiFeOOH, the researchers aim to optimize the carrier transport path and separation efficiency, thereby significantly enhancing the performance of photoelectrochemical water splitting. ### Background and Motivation With the increasing demand for fossil fuels, the energy crisis and environmental pollution are becoming more and more serious. As a technology for converting solar energy into stable, environmentally - friendly, and renewable clean energy (such as hydrogen), photoelectrochemical (PEC) water splitting has received extensive attention. In the PEC system, the design of photoanode materials is crucial for achieving high - efficiency photoelectrochemical performance. Although ZnIn₂S₄ has attracted attention due to its strong absorption of visible light, non - toxicity, low cost, and easy synthesis, its low carrier transport efficiency and separation efficiency limit its application. ### Solutions To overcome these problems, the researchers adopted the following strategies: 1. **Constructing 2D/2D heterojunction**: The MoS₂/ZnIn₂S₄ heterojunction was synthesized by the hydrothermal method, and the carrier transport path was optimized by using density functional theory (DFT) calculations and the large specific surface area of 2D nanosheets. 2. **Introducing cocatalyst**: The bimetallic hydroxide NiFeOOH was used as a cocatalyst to further improve the carrier separation efficiency. ### Experimental Results The experimental results show that the photocurrent density of the MoS₂/ZnIn₂S₄/NiFeOOH photoanode reaches 0.74 mA/cm² at 1.23 V vs. RHE, which is 2.6 times and 5.7 times that of pure MoS₂ and ZnIn₂S₄, respectively. In addition, this photoanode also has the highest bulk - phase charge separation efficiency (22.8%) and surface charge transport efficiency (64.6%). ### Conclusion This work provides an effective strategy to significantly improve the carrier transport efficiency and separation efficiency of photoanodes in photoelectrochemical water splitting by designing 2D/2D heterojunctions and combining with cocatalysts. This provides new ideas for the development of high - performance photoelectrochemical water - splitting systems.