Influences of Heat‐Treatment, Particle Arrangement, and Binder Addition on the Mechanical Robustness of Structurally Colored Coatings Formed with Monodisperse SiO2 Spheres

Takahiro Yamanaka,Naoki Tarutani,Kiyofumi Katagiri,Kei Inumaru,Yukikazu Takeoka

DOI: https://doi.org/10.1002/adem.202400814

IF: 3.6

2024-05-31

Advanced Engineering Materials

Abstract:This paper highlights the critical factors influencing the mechanical robustness of structurally colored coatings formed as arrays of monodisperse SiO2 particles. Various types of coatings can be fabricated using electrophoretic deposition (EPD) techniques. Anodic EPD generates coatings with colloidal crystalline structures, iridescent structural color, and noteworthy mechanical robustness owing to interparticle necking during heat treatment, even in the absence of binder additives. Conversely, coatings prepared via cathodic EPD exhibit non‐iridescent structural color and colloidal amorphous structure, with only marginally improved mechanical robustness after high‐temperature treatment. However, when Mg(OH)2 is co‐deposited during EPD in the coating, the resultant film exhibits strong adhesion between particles and between particles and the substrate—as evidenced by minimal peeling from the substrate even after ultrasonication for 6 h—owing to the binding effect of MgO, which is converted from Mg(OH)2 via heat treatment. The robustness of the film is not dictated by the size of the SiO2 particles, suggesting that this approach can be applied to structurally colored coatings of various colors. Consequently, the results suggest that EPD with the addition of a binder and heat treatment can be used to fabricate particle‐array‐type coatings with extremely high mechanical robustness. This article is protected by copyright. All rights reserved.

materials science, multidisciplinary