Abstract:In order to investigate the diffuse pollution mechanisms of high-concentration dusts in the blasting driving face, the airflow-dust coupled model was constructed based on CFD-DEM coupled model; the diffusion rules of the dusts with different diameters at microscopic scale were analyzed in combination with the field measured results. The simulation results demonstrate that single-exhaust ventilation exhibited more favorable dust suppression performance than single-forced ventilation. Under single-exhaust ventilation condition, the motion trajectories of the dusts with the diameter smaller than 20 μm were close to the airflow streamline and these dusts were mainly distributed near the footway walls; by contrast, under single-forced ventilation condition, the motion trajectories of the dust particles with a diameter range of 20~40 μm were close to the airflow streamlines, and a large number of dusts with the diameter smaller than 20 μm accumulated in the regions 5 m and 17~25 m away from the head-on section. Moreover, under the single-exhaust ventilation, the relationship between dust diameter D and negative-pressured-induced dust emission ratio P can be expressed as P = − 25.03ln(D) + 110.39, and the dust emission ratio was up to 74.36% for 7-μm dusts, and the path-dependent settling behaviors of the dusts mainly occurred around the head-on section; under single-forced ventilation condition, the z value of the dusts with the diameter over 20 μm decreased and the dusts with a diameter smaller than 7 μm are particularly harmful to human health, but their settling ratios were below 22.36%.Graphical abstractThe airflow-dust CFD-DEM coupling model was established. The numerical simulation results were verified. The migration laws of airflow field were obtained in a blasting driving face. The diffusion laws of dusts were obtained after blasting.

Study on the factors influencing the performance of dust collection hood of angle grinder based on CFD-DEM simulation

Performance study of a new type of collection equipment for unorganized fumes from aluminum electrolysis

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Micro-scale pollution mechanism of dust diffusion in a blasting driving face based on CFD-DEM coupled model

CFD Modeling of Ventilation and Dust Flow Behavior in Polishing and the Design of an Innovative Wet Dust Removal System

Investigation of influencing factors of wear in a sandblasting machine by CFD-DEM coupling

Study on a Semi-Resolved CFD-DEM Method for Rod-Like Particles in a Gas-Solid Fluidized Bed

3D numerical simulation of particles collection in a high-temperature wire-cylinder electrostatic precipitator

CFD-DEM Study on the Synergistic Effect of Coke Consumption and Particle Dynamics in the Blast Furnace Raceway

Enhancement of particle collection efficiency considering the structural interplay: particle motion characteristics analysis

Dust Suppression Analysis of a New Spiral Hopper Using CFD-DEM Simulations and Experiments

Influence of outdoor meteorological parameters on the indoor environment of blast furnace yard

Dust Collection's Efficiency of Low Reynolds Purifier via Computational Fluid Dynamic Simulation and Optimization

A Comparative Study of the Performance of Different Particle Models in Simulating Particle Charging and Burden Distribution in a Blast Furnace Within the DEM Framework

CFD-DEM coupled calculation of entrained air and particles movement characteristics during particles flow impacting the wall process

Simulation for the Design and Optimization of Dust Collection Box of Highway Sweeper

Semi-resolved CFD-DEM modeling of gas-particle two-phase flow in the micro-abrasive air jet machining

Research on dust control technology and numerical simulation of conical guiding air curtain in fully mechanized excavation face

Simulation for the Design of Dust Suction System of Highway Sweeper

Computational Fluid Dynamics Analysis of Wet Dust Removal in High-Gravity Countercurrent Rotating Packed Bed

3D Simulation for Dynamic Characteristics of Airflow and Dust Control in A Laneway of Coal Mine