Densities and excess molar volumes of thiophene + heptane and thiophene + octane at temperatures between (313 K and 363) K and pressures up to 25 MPa using three calibration methods

Rubén P. Mendo-Sánchez,Alfredo Pimentel-Rodas,Angel M. Notario-López,Luis A. Galicia-Luna

DOI: https://doi.org/10.1016/j.jct.2024.107250

IF: 3.269

2024-05-01

The Journal of Chemical Thermodynamics

Abstract:New compressed liquid densities (ρ) of thiophene + heptane and thiophene + octane are reported in the temperature range from (313 to 363) K, with pressure up to 25 MPa. The compositions are x(1) = 0.1049, 0.2471, 0.5097, 0.7494, and 0.8994 for thiophene (1) + heptane (2), and x(1) = 0.1042, 0.2530, 0.5037, 0.7516, and 0.8988 for thiophene (1) + octane (2). The experimental system uses a vibrating tube densimeter (VTD) and three calibration methods (the first uses hexane and water, the second uses nitrogen and water, and the third uses water and applying vacuum to the VTD as calibration reference fluids). The reported density data are determined using the third method, which notifies the lowest uncertainty and estimates a maximum relative expanded uncertainty ( k = 2 ) of 0.21 % in the temperature range from (313 to 363) K and pressures up to 25 MPa. The pure compound densities were calculated from previous density measurements represented by the Pimentel-Galicia model. This empirical correlation of the pure compounds was used before for the excess molar volume calculation. The experimental data of the mixtures reported in this work were modeled by the Pimentel-Galicia model at each composition with deviations not higher than 0.07 %. The combined standard uncertainty for composition (considering the purities of the samples) is u c x = 0.0026. Finally, the isothermal compressibility and isobaric thermal expansivity were evaluated from density data.

thermodynamics,chemistry, physical

What problem does this paper attempt to address?

Densities and excess molar volumes of thiophene + heptane and thiophene + octane at temperatures between (313 K and 363) K and pressures up to 25 MPa using three calibration methods

Densities and Viscosities of Binary Mixtures of Cyclopropanecarboxylic Acid with Methanol, Ethanol, Propan-1-ol, and Butan-1-ol at Different Temperatures

PvT properties of heptane, octane, nonane, decane, thiophene, and eugenol at temperatures between (313 and 363) K and pressures up to 25 MPa comparing three calibration methods

Densities and Viscosities of Binary Mixtures of Methyl 4-Chlorobutyrate with Aromatic Hydrocarbons at T = (298.15 to 318.15) K

Liquid Densities of N-Octane, Ethylcyclohexane and Their Binary Mixtures {(x) N-Octane) + (1 − X) Ethylcyclohexane} at Temperatures from (283 to 363) K and Pressures Up to 60 MPa

Isobaric Heat Capacity Measurements for Dimethyl Ether and 1,1-Difluoroethane in the Liquid Phase at Temperatures from 305 K to 365 K and Pressures Up to 5 Mpa

PρT Measurements and Modelling of (N-Decane + M-Xylene) Mixtures from 293.15 K to 363.15 K at Pressures Up to 60 MPa

Liquid Densities for N-Decane + P-Xylene Mixtures from 293.15 K to 363.15 K at Pressures Up to 60 MPa

Excess Molar Volumes of N -Alkanes-thiophene Mixtures at 25°C

Compressed Liquid Densities for Cyclopentane/n-Heptane Mixtures from 293.15 K to 363.15 K at Pressures Up to 70 MPa

Liquid Density of Biofuel Mixtures: 1-Heptanol + Heptane System at Pressures Up to 140 Mpa and Temperatures from 298.15 K to 393.15 K

Densities And Viscosities Of Binary Mixtures Of 2,2,4-Trimethylpentane+1-Propanol,+1-Pentanol,+1-Hexanol, And+1-Heptanol From (298.15 To 323.15) K

High-Pressure Densities and Derived Thermodynamic Properties of Cyclopentane/n-Octane Mixtures from 293.15 K to 363.15 K

Liquid density of binary mixtures of n -pentane and n -dodecane at temperatures from 283K to 363K and pressures up to 100MPa

Thermodynamic Properties of Binary Mixtures of<i>p</i>-Xylene with Cyclohexane, Heptane, Octane, and<i>N</i>-Methyl-2-pyrrolidone at Several Temperatures

Liquid Density of N-Pentene, N-Hexene, and N-Heptene at Temperatures from 283.15 to 363.15 K and Pressures Up to 100 MPa

Measurement of the Thermal Conductivities of Toluene, Cyclohexane, and Diethyl Ether at Pressures up to 15.1 MPa and Their Binary Mixtures at Pressures 0.1 and 10.1 MPa from 291 to 351 K

Densities And Viscosities For The Ternary System Of Exo-Tetrahydrodicyclopentadiene (1) + Methylcyclohexane (2) + Cyclopropanemethanol (3) And Its Binaries At T=293.15 To 333.15 K

High-pressure Densities of N-Decane+o-xylene Mixtures: Measurement and Modelling

Density, Viscosity, and Vapor Pressure of 1,1,3,5,5-Pentamethyl-3-phenyltrisiloxane, 3-(Dimethylsilyloxy)-1,1,5,5-tetramethyl-3-phenyltrisiloxane, and 1,1,5,5-Tetramethyl-3,3-diphenyltrisiloxane

Excess Molar Volumes and Surface Tensions of 1,2,4-Trimethylbenzene and 1,3,5-Trimethylbenzene with 1,1-Diethoxyethane and 2,2-Dimethoxypropane at (298.15, 308.15, and 313.15) K