Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

Impact of fibers on pumping flow: an analysis by CFD-DEM simulations and experiments

Numerical Simulation of the Motion of Cellulose Fibers in a Centrifugal Cleaner

Effect of Fibers on the Flow Property of Turbulent Fiber Suspensions in a Contraction

Simulation of fiber suspension flowing through a stock pump impeller with two-way coupling

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Structure and Properties of Concentrated Fiber Suspensions in A Shear Flow

Numerical Prediction of the Flow Property in Round Turbulent Jet of Fiber Suspension

Impeller design criterion based on numerical simulation of stock pump flow field and its application

Effect Of Fiber Additives On Flow In Journal Bearings

NUMERICAL RESEARCH ON THE EFFECT OF FIBERS ON THE PROPERTY OF TURBULENT FIBER SUSPENSION IN A CHANNEL

Characteristics of Fiber Suspension Flow in a Turbulent Boundary Layer

Experimental Research on the Hydrodynamic Instability of Fiber Suspensions in Channel Flow

The Influence of the Geometric Parameters of an Impeller on the Transport Capability of Long Flexible Fiber in a Non-Clogging Pump

CFD simulations of fiber-fiber interaction in a hollow fiber membrane bundle: Fiber distance and position matters

A New Expression for the Velocity Profile in the Turbulent Pipe Flows of Fiber Suspension

CFD Analysis on a Turbulence Generator of Medium Consistency Pump

Fiber Orientation Distribution and Rheological Properties of Fiber Suspension in a Turbulent Jet

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Analysis of particle motion and wear characteristics for mixed particle sizes in centrifugal pumps

A New Formula for Predicting the Velocity Distribution in the Turbulent Fiber Suspensions of A Channel Flow

Discrete element method-computational fluid dynamics analyses of flexible fibre fluidization