Abstract:The instability of the temperature field distribution in clutch friction pair tends to increase exponentially with time when the relative velocity is greater than a certain critical value, which indicates the system enters a state of thermoelastic instability. During high-speed frictional sliding at a high temperature and high pressure, thermoelastic instability will generate local high temperature on friction pair and then cause high-frequency vibration, warping, fatigue fracture, and so on. With the aim of studying the problems arising from local hot spots and the mechanism behind the characteristics of temperature field in friction pair, a thermoelastic finite element analysis model was established for friction pair of heavy-duty vehicle clutch in this paper. The characteristics of thermoelastic stress and temperature distribution under different conditions were obtained by simulation analysis where different values were applied to groove distribution parameters such as number, angle, depth, and width. Experiments were carried out on a friction pair to test its thermoelastic instability. Results show that as the value of each groove distribution parameter increases, the fitting curves of the average temperature, range, and the temperature inhomogeneity coefficient of the temperature field are in forms of oscillation. The average temperature and range have the same trends. The paper concludes that the average temperature range and inhomogeneity coefficient of the temperature field distribute in order, so that the optimized structural parameters were obtained.

Study on the groove area effects on the friction-wear properties of a Cu-based wet clutch

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Parametric Analysis of the Drag Torque Model of Wet Multi-Plate Friction Clutch with Groove Consideration

Experimental and Theoretical Analysis of the Drag Torque in Wet Clutches

Influence of Groove Type on Friction Coefficient of Wet Friction Clutch Pair

Simulation and Experiment on Dynamic Engagement Characteristics of Wet Clutch

Simulation Research on the Drag Torque of Disengaged Wet Clutches

Parametric analysis of wear factors of a wet clutch friction material with different groove patterns

Effects of operating conditions on the tribological behavior of a wet multi-disc clutch during the running-in process

Influences of the Contact State between Friction Pairs on the Thermodynamic Characteristics of a Multi-Disc Clutch

Influence of Material Parameters on the Contact Pressure Characteristics of a Multi-Disc Clutch

The performance of Cu-based friction material in dry clutch engagement

Influence upon temperature field distribution with straight grooves parameters of clutch friction disk

Sliding State Analysis of Fractal Rough Interface Based on the Finite Element Method

Transient temperature characteristics of friction clutch disc considering thermal contact conductance under sliding conditions

Investigation of thermal behavior of a novel multi-conical friction pair during wet clutch's engagement based on finite difference method

Simulation and Experimental Study of Engagement Process with Groove Consideration

Modeling of the Drag Torque of the Disengaged Grooved Wet Clutches with Waviness

Influences of Surface Texture on the Friction Characteristics of Powder Metallurgy Clutch Disks

Experimental investigation on the friction and sealing characteristics of narrow end-face seal ring with spiral grooves for wet clutch

Study on dynamic characteristics variation mechanism of wet-clutches during the filling phase considering temperature and rotational speed of the oil