Abstract:The force sensor is key to the performance of atomic force microscopy (AFM). Nowadays, most AFMs use micro-machined force sensors made from silicon, but piezoelectric quartz sensors are applied at an increasing rate, mainly in vacuum. These self sensing force sensors allow a relatively easy upgrade of a scanning tunneling microscope to a combined scanning tunneling/atomic force microscope. Two fundamentally different types of quartz sensors have achieved atomic resolution: the 'needle sensor' that is based on a length extensional resonator and the 'qPlus sensor' that is based on a tuning fork. Here, we calculate and measure the noise characteristics of these sensors. We find four noise sources: deflection detector noise, thermal noise, oscillator noise and thermal drift noise. We calculate the effect of these noise sources as a factor of sensor stiffness, bandwidth and oscillation amplitude. We find that for self sensing quartz sensors, the deflection detector noise is independent of sensor stiffness, while the remaining three noise sources increase strongly with sensor stiffness. Deflection detector noise increases with bandwidth to the power of 1.5, while thermal noise and oscillator noise are proportional to the square root of the bandwidth. Thermal drift noise, however, is inversely proportional to bandwidth. The first three noise sources are inversely proportional to amplitude while thermal drift noise is independent of the amplitude. Thus, we show that the earlier finding that quoted optimal signal-to-noise ratio for oscillation amplitudes similar to the range of the forces is still correct when considering all four frequency noise contributions. Finally, we suggest how the signal-to-noise ratio of the sensors can be further improved and briefly discuss the challenges of mounting tips.

High speed nanotribology with quartz crystal resonators via Atomic Force Microscopy

High Quality-Factor Quartz Tuning Fork Glass Probe Used In Tapping Mode Atomic Force Microscopy For Surface Profile Measurement

Towards High Accuracy Surface Profile Characterization in Atomic Force Microscopy

Improved Sensitivity for Subsurface Imaging by Contact Resonance Atomic Force Microscopy Using Fano Peaks

High speed friction microscopy and nanoscale friction coefficient mapping

Characterization of strongly coupled quartz tuning fork sensors for precision force measurement in atomic force microscopy

A comparsion of force sensors for atomic force microscopy based on quartz tuning forks and length extensional resonators

Calibration of the Effective Spring Constant of Ultra-Short Cantilevers for A High-Speed Atomic Force Microscope

Measurement of Sub-Surface Microstructures Based on a Developed Ultrasonic Atomic Force Microscopy

Application of Triangular Atomic Force Microscopy Cantilevers to Friction Measurement with the Improved Parallel Scan Method.

Velocity-dependent nano-scale friction under atomic force microscope

High-resolution measurement of atomic force microscope cantilever resonance frequency

Torsional Oscillator for Internal-Friction Data at 100-Khz

Direct Measurement of Plowing Friction and Wear of a Polymer Thin Film Using the Atomic Force Microscope

Imaging high-speed friction at the nanometer scale

Simultaneous detection of vertical and lateral forces by bimodal AFM utilizing a quartz tuning fork sensor with a long tip

Improved Parallel Scan Method for Nanofriction Force Measurement with Atomic Force Microscopy

Friction Determination by Atomic Force Microscopy in Field of Biochemical Science

Very high frequency probes for atomic force microscopy with silicon optomechanics

Friction Enhancement and Autoparametric Resonance

Internal and interfacial friction in the dynamics of soft/solid interfaces