Abstract:This study aims to investigate the magnitude and distribution of welding residual stresses in orthotropic steel decks stiffened with U-shaped ribs. Numerical simulation of the welding residual stresses is performed using the thermal elastic–plastic finite element method. The residual stresses are subsequently measured using the hole-drilling strain-gage method. Based on the results of this study, it can be determined that: (1) The longitudinal welding residual stresses (σz) in the weld zones are tensile stresses, where the peak value exceeds the minimum yield strength (fyl); however, relatively low compressive stresses exist in the areas located far away from the welds; (2) The stress gradient in the weld zone is steep, and the widths of the areas experiencing tensile stress are narrow; (3) In the case of the upper surface of the deck, the weld that is first deposited has the highest peak stress, while similar stresses are determined for the remaining welds. In the case of the lower surface of the deck, the peak stress in the weld zones is greater than that on the upper surface; (4) In the case of the weld zone of the U-shaped ribs, the tensile stresses reach up to 1.15fyl; however, at locations a short distance away from the welds, the σz varies from tensile to compressive, and finally transforms into a small tensile stress at the base of the U-shaped ribs. In addition, the simulated and measured σz are compared, and the deviation between them is analyzed.

A Study on Remaining Efficiency of Thermal Straightening after Block Lifting

Investigation of the Fatigue Stress of Orthotropic Steel Decks Based on an Arch Bridge with the Application of the Arlequin Method

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Systematization of heat straightening process of stiffened plate by surface flattening

Research on key technologies for straightening pocketed aircraft frame parts

Heat Straightening Damaged Steel Plate Elements

Analysis on Installing Stability of 50 M T-Beam by Direct Lifting

Residual Stress Reduction through Thermo-mechanical Tensioning for an Orthotropic Steel Bridge Deck

Investigation of Thermal Effects of Flame Straightening on High-Strength Steels

Multi‐Response Optimization of an Orthotropic Steel Deck Section with Thermo‐mechanical Tensioning

Research on welding deformation for box girder of bridge crane based on thermal elasto-plastic theory

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Numerical Calculation of High-Strength-Steel Saddle Plate Forming Suitable for Lightweight Construction of Ships

Mechanical Analysis of the Sandwich Plates Method for Strengthening Fatigue Cracks in Orthotropic Steel Bridge Decks

On the modelling of distorted thin-walled stiffened panels via a scale reduction approach for a simplified structural stress analysis

Comprehensive exploration of technological tensioning effects in welded thin plate girders: an in-depth investigation

Numerical Simulation and Measurement of Welding Residual Stresses in Orthotropic Steel Decks Stiffened with U-Shaped Ribs

A Study on Heat Input Control and a Quality Evaluation Algorithm to Prevent Toughness Deterioration of the Heat-Affected Zone in the Fiber Laser Welding Process of ASTM A553-1 (9% Nickel Steel) Material

The prediction of deformation in the process of erecting ship blocks based on inherent strain approach

Welding Distortion Prediction and Mitigation in Thick Steel Plate Structures on Ships