Abstract:Wireless networks are built upon a shared medium that makes it easy for adversaries to launch jamming-style attacks. These attacks can be easily accomplished by an adversary emitting radio frequency signals that do not follow an underlying MAC protocol. Jamming attacks can severely interfere with the normal operation of wireless networks and, consequently, mechanisms are needed that can cope with jamming attacks. In this paper, we examine radio interference attacks from both sides of the issue: first, we study the problem of conducting radio interference attacks on wireless networks, and second we examine the critical issue of diagnosing the presence of jamming attacks. Specifically, we propose four different jamming attack models that can be used by an adversary to disable the operation of a wireless network, and evaluate their effectiveness in terms of how each method affects the ability of a wireless node to send and receive packets. We then discuss different measurements that serve as the basis for detecting a jamming attack, and explore scenarios where each measurement by itself is not enough to reliably classify the presence of a jamming attack. In particular, we observe that signal strength and carrier sensing time are unable to conclusively detect the presence of a jammer. Further, we observe that although by using packet delivery ratio we may differentiate between congested and jammed scenarios, we are nonetheless unable to conclude whether poor link utility is due to jamming or the mobility of nodes. The fact that no single measurement is sufficient for reliably classifying the presence of a jammer is an important observation, and necessitates the development of enhanced detection schemes that can remove ambiguity when detecting a jammer. To address this need, we propose two enhanced detection protocols that employ consistency checking. The first scheme employs signal strength measurements as a reactive consistency check for poor packet delivery ratios, while the second scheme employs location information to serve as the consistency check. Throughout our discussions, we examine the feasibility and effectiveness of jamming attacks and detection schemes using the MICA2 Mote platform.

Characterization of anti-jamming effect on the Joint Tactical Information Distribution System (JTIDS) operating in complicated electromagnetic environment

Anti-jamming Performance Simulation and Analysis of Tactical Data Link Communication System

Research on Anti-Jam performance of Noncoherent JTIDS

Disrupting MIMO Communications with Optimal Jamming Signal Design

JTIDS signal simulation based on Simulink

Characterization Of Emi Effects In Communication Data Link System In The Presence Of High-Power Radar Radiation

An Electronic Jamming Method Based on a Distributed Information Sharing Mechanism

The Feasibility of Launching and Detecting Jamming Attacks in Wireless Networks.

Anti-jamming Timing Channels for Wireless Networks

A New Electronic Jamming Method Inspried from Bionics System

Jammer-Assisted Secure Precoding and Feedback Design for MIMO IoT Networks

Reactive Jamming and Attack Mitigation over Cross-Technology Communication Links

Improving the jam resistance performance of UWB impulse radio independently of time hopping codes

Joint communication interference system design based on parameter modulation

Illegal Intelligent Reflecting Surface Based Active Channel Aging: When Jammer Can Attack Without Power and CSI

Jam resistance performance of UWB BPM impulse radio with time hopping vs. direct sequence

Jamming Modulation: An Active Anti-Jamming Scheme

Anti-jamming Technology in Small Satellite Communication

Secure Transmission for Wireless Communication Systems with Friendly Jammers

Dynamic Spectrum Anti-Jamming Communications: Challenges and Opportunities