Abstract:Wireless networks are built upon a shared medium that makes it easy for adversaries to launch jamming-style attacks. These attacks can be easily accomplished by an adversary emitting radio frequency signals that do not follow an underlying MAC protocol. Jamming attacks can severely interfere with the normal operation of wireless networks and, consequently, mechanisms are needed that can cope with jamming attacks. In this paper, we examine radio interference attacks from both sides of the issue: first, we study the problem of conducting radio interference attacks on wireless networks, and second we examine the critical issue of diagnosing the presence of jamming attacks. Specifically, we propose four different jamming attack models that can be used by an adversary to disable the operation of a wireless network, and evaluate their effectiveness in terms of how each method affects the ability of a wireless node to send and receive packets. We then discuss different measurements that serve as the basis for detecting a jamming attack, and explore scenarios where each measurement by itself is not enough to reliably classify the presence of a jamming attack. In particular, we observe that signal strength and carrier sensing time are unable to conclusively detect the presence of a jammer. Further, we observe that although by using packet delivery ratio we may differentiate between congested and jammed scenarios, we are nonetheless unable to conclude whether poor link utility is due to jamming or the mobility of nodes. The fact that no single measurement is sufficient for reliably classifying the presence of a jammer is an important observation, and necessitates the development of enhanced detection schemes that can remove ambiguity when detecting a jammer. To address this need, we propose two enhanced detection protocols that employ consistency checking. The first scheme employs signal strength measurements as a reactive consistency check for poor packet delivery ratios, while the second scheme employs location information to serve as the consistency check. Throughout our discussions, we examine the feasibility and effectiveness of jamming attacks and detection schemes using the MICA2 Mote platform.

Research on Anti-Jam performance of Noncoherent JTIDS

Characterization of anti-jamming effect on the Joint Tactical Information Distribution System (JTIDS) operating in complicated electromagnetic environment

Anti-jamming Performance Simulation and Analysis of Tactical Data Link Communication System

The Interference Effect Evaluation Indicators of Radar Based on Penetration Path

JTIDS signal simulation based on Simulink

Study of Sidelobe Noise Blanket Jamming to IFF System Interrogator

Anti-jamming Timing Channels for Wireless Networks

The Feasibility of Launching and Detecting Jamming Attacks in Wireless Networks.

A New Electronic Jamming Method Inspried from Bionics System

Analysis of Jamming on TT & C Monopulse Tracking System

Improving the jam resistance performance of UWB impulse radio independently of time hopping codes

Jamming Modulation: An Active Anti-Jamming Scheme

Research on an Intra-Pulse Orthogonal Waveform and Methods Resisting Interrupted-Sampling Repeater Jamming within the Same Frequency Band

Interrupted-sampling multi-strategy forwarding jamming with amplitude constraints based on simultaneous transmission and reception technology

Illegal Intelligent Reflecting Surface Based Active Channel Aging: When Jammer Can Attack Without Power and CSI

Joint communication interference system design based on parameter modulation

Anti-Jamming Precoding Against Disco Intelligent Reflecting Surfaces Based Fully-Passive Jamming Attacks

Study on Intelligent Counter-Countermeasures of Infrared Imaging Air-to-air Missiles

Characteristics Analysis of Interrupted-Sampling Repeater Jamming

Research on anti-jamming and anti-interception performance of MC-CDMA system based on Code-Hopping