Abstract:In general, with the addition of solutes, the yield strength of alloys is expected to increase and this phenomenon is known as solid solution strengthening. However, reports on the ``anomalous'' softening with alloying additions are not uncommon; for example, it is known that the heterogeneous nucleation of dislocations at the sites of solute atoms can lead to softening. In this study, using Molecular Dynamics (MD) simulations, we show anomalous softening in Cu-Al alloys deformed at 300 K; specifically, not only the yield stress but also the magnitude of stress drop at yield decrease with increasing Al content. We calculate the stress needed for the homogeneous nucleation of partial dislocation loops using a continuum model. One of the key inputs to the continuum model is the stacking fault energy (SFE). We carry out the thermodynamic integration to evaluate the free energies in crystals with and without the stacking faults and hence calculate the SFE as a function of Al content at 300 K. Using the SFE values thus obtained we show that softening is a consequence of the reduction of SFE values with the addition of Al in a system where yielding is controlled by the nucleation of dislocation loops. Specifically, the results of continuum model are in good agreement with MD simulation results of pure copper. However, in the Cu-Al alloys, the drop in yield strength can only be explained using a combination of the continuum model (which assumes homogeneous nucleation), and the reduction in heterogeneous nucleation barrier (which is a function of the ratio of the unstable and stable stacking fault energies). We show that the decrease in stress drop can be rationalised in terms of the stored energy available at yielding -- the stored energy at yielding decreases with increasing Al, and, as a result, the maximum dislocation density decreases with increasing Al content.

Effect of temperature-induced solute distribution on stacking fault energy in Mg–X(X = Li, Cu, Zn, Al, Y and Zr) solid solution: a first-principles study

Local Lattice Distortion Mediated Formation of Stacking Faults in Mg Alloys

Solute effect on basal and prismatic slip systems of Mg

First Principles Studies of Stacking Fault Energies in Ternary Magnesium Alloys

A comprehensive theoretical scheme for understanding the core structure and the mechanical behavior of basal dislocations with solute atmosphere in Mg alloys

Local atomic ordering strategy for high strength Mg alloy design by first-principle calculations

First-principles Study on Solute-Basal Dislocation Interaction in Mg Alloys

Generalized Stacking Fault Energy of {10-11}<11-23> Slip System in Mg-Based Binary Alloys: A First Principles Study

Predicting the variation of stacking fault energy for binary Cu alloys by first-principles calculations

Thermodynamic origin of solute-enriched stacking-fault in dilute Mg-Zn-Y alloys

Effects of SMAT Temperature and Stacking Fault Energy on the Mechanical Properties and Microstructure Evolution of Cu-Al-Zn Alloys

Effects of Nb concentration and temperature on generalized stacking fault energy of Zr–Nb alloys by molecular dynamics simulations

Influence of Stacking Fault Energy on Formation of Long Period Stacking Ordered Structures in Mg–Zn–Y–Zr Alloys

First-principles data for solid-solution strengthening of magnesium: From geometry and chemistry to properties

Stacking fault energy induced softening in the nucleation limited plasticity regime: a molecular dynamics study on Cu-Al alloys

Solute effects on interfacial dislocation emission in nanomaterials: nucleation site competition and neutralization

Effect of Strain on the Intrinsic Stacking Fault Energy of Fcc Co: a First-Principles Study

First-principle study of the basal-plane stacking fault energies of ternary Mg alloys

Interfacial Dislocations Dominated Lateral Growth of Long-Period Stacking Ordered Phase in Mg Alloys

Quantitative evaluation of the short-range order strengthening effect on solid solution and GB strength of Mg–Y alloys by ab initio calculations

Can experiment determine the stacking fault energy of metastable alloys?