Abstract:Transverse 2D phase space distribution of a 2.1 MeV, 5 mA H$^-$ beam is measured at the PIPIT test accelerator at Fermilab with an Allison scanner. The paper describes the design, calibration, and performance of the scanner as well as the main results of the beam measurements. Analyses of the recorded phase portraits are performed primarily in action-phase coordinates; the stability of the action under linear optics makes it easier to compare measurements taken with different beamline conditions, e.g. in various locations. The intensity of a single measured point (\pixel") is proportional to the phase density in the corresponding portion of the beam. When the Twiss parameters are calculated using only the high-phase density part of the beam, the pixel intensity in the beam core is found to be decreasing exponentially with action and to be phase-independent. Outside of the core, the intensities decrease with action at a significantly slower rate than in the core. This `tail' comprises 10-30% of the beam, with 0.1% of the total measured intensity extending beyond the action 10-20 times larger than the rms emittance. The transition from the core to the tail is accompanied by the appearance of a strong phase dependence, which is characterized in action-phase coordinates by two `branches' extending beyond the core. A set of selected measurements shows, in part, that there is no measurable emittance dilution along the beam line in the main portion of the beam; the beam parameters are practically constant over a 0.5 ms pulse; and scraping in various parts of the beam line is an effective way to decrease the transverse tails by removing the branches.

Beam Dynamics Studies at the PIP-II Injector Test Facility

Final Physics Design of Proton Improvement Plan-II At Fermilab

Optimization of Superconducting Linac for Proton Improvement Plan-II (PIP-II)

Physics Opportunities at a Beam Dump Facility at PIP-II at Fermilab and Beyond

Beam Commissioning Status and Results of the FNAL PIP2IT Linear Accelerator RFQ

Measurements of a 2.1 MeV H$^-$ beam with an Allison scanner

PIII Project Overview and Status

PIP2-BD: GeV Proton Beam Dump at Fermilab's PIP-II Linac

Initial PIP-II Beam Current Monitor Fault Case Analyses & Beam Position Monitor Linearity Studies in CST Studio Suite

Controls at the Fermilab PIP-II Superconducting Linac

Beam dynamics studies of the photo-injector in low-charge operation mode for the ERL test facility at IHEP

The Ionization Profile Monitors in the Recycler Ring

Progress on an Electron Beam Profile Monitor at the Fermilab Main Injector

Overview and status of the PIP-II cryogenic system

Early Beam Injection Scheme for the Fermilab Booster: A Path for Intensity Upgrade

Full-Cycle Simulations of the Fermilab Booster

IOTA Proton Injector Beamline Installation

Space charge dominated momentum spread and compensation strategies in the post-linac section of Proton Improvement Plan-II at Fermilab

Quadrupole multiplet for medium energy beam transport for proton improvement plan −2

Installation, commissioning, and testing of the HB650 CM at PIP2IT

Radiation Shielding Analysis for the PIP-II Linac at Fermilab