Abstract:Direct time-of-flight (dToF) ranging sensors based on single-photon avalanche diodes (SPADs) have been used as a prominent depth-sensing devices. Time-to-digital converters (TDCs) and histogram builders have become the standard for dToF sensors. However, one of the main current issues is the bin width of the histogram, which limits the accuracy of depth without TDC architecture modifications. SPAD-based light detection and ranging (LiDAR) systems require new methods to overcome their inherent drawbacks for accurate 3D ranging. In this work, we report an optimal matched filter to process the raw data of the histogram to obtain high-accuracy depth. This method is performed by feeding the raw data of the histogram into the different matched filters and using the Center-of-Mass (CoM) algorithm for depth extraction. Comparing the measurement results of different matched filters, the filter with the highest depth accuracy can be obtained. Finally, we implemented a dToF system-on-chip (SoC) ranging sensor. The sensor is made of a configurable array of 16 × 16 SPADs, a 940 nm vertical-cavity surface-emitting laser (VCSEL), an integrated VCSEL driver, and an embedded microcontroller unit (MCU) core to implement the best matched filter. To achieve suitably high reliability and low cost, the above-mentioned features are all packaged into one module for ranging. The system resulted in a precision of better than 5 mm within 6 m with 80% reflectance of the target, and had a precision better than 8 mm at a distance within 4 m with 18% reflectance of the target.

Range extended SP-iToF LiDAR with time-gated and spatially fused imaging

Ultrafast Parallel LiDAR with Time-encoding and Spectral Scanning: Breaking the Time-of-flight Limit

Long Range 3D Imaging Through Atmospheric Obscurants Using Array-Based Single-Photon LiDAR.

Unlocking The Potential of Lidar: Principles, Applications, And Future Prospects

A review of ToF-based LiDAR

Depth estimation in SPAD-based LIDAR sensors

Solid-State Dtof LiDAR System Using an Eight-Channel Addressable, 20w/ch Transmitter, and a 128x128 SPAD Receiver with SNR-Based Pixel Binning and Resolution Upscaling.

Long-range photon-efficient 3D imaging without range ambiguity

SiPM-based LiDAR with multipulse sequence modulation and multithreshold signal processing

Airborne Single-Photon LiDAR Towards a Small-Sized and Low-Power Payload

A dToF Ranging Sensor with Accurate Photon Detector Measurements for LiDAR Applications

Single-photon imaging over 200 km

Integration Time and Time-Bin Width in Ranging Histograms for a Photon-Counting LiDAR

Ultrafast Parallel Single-Pixel LiDAR with All-Optical Spectro-Temporal Encoding

Long-range High-Speed Laser Imaging Based on VCSEL Array and MPPC Array.

All-Time Single-Photon 3d Imaging Over 21 Km

Development of a near-infrared single-photon 3D imaging LiDAR based on 64×64 InGaAs/InP array detector and Risley-prism scanner

Establishing equivalent circuits of mounted, high-power VCSEL arrays for iToF cameras

Single-photon Computational 3D Imaging at 45 Km

Vehicle-mounted Imaging Lidar with Nonuniform Distribution of Instantaneous Field of View

DTOF Image LiDAR With Stray Light Suppression and Equivalent Sampling Technology