Abstract:Systematic assessments of cathodoluminescence (CL) spectroscopy, Raman spectroscopy (RS), and X-ray diffraction (XRD) are presented for pure zirconia and for a series of Y-doped zirconia powders (henceforth, simply referred to as undoped ZrO2 and YSZ powders, respectively) synthesized according to a coprecipitation method of Zr and Y chlorides. Emphasis is placed here on spectral emissions related to oxygen-vacancy sites (i.e., oxygen hole states) equally detected from undoped and Y-doped ZrO2 samples, either as intrinsic defects or, extrinsically induced, by means of cathodoluminescence. Most counterintuitively, the undoped ZrO2 sample (i.e., the one with presumably the lowest amount of oxygen vacancies) experienced the strongest CL emission. A progressive "quenching" effect on CL emission with increasing the fraction of Y(3+) dopant could also be observed because the intrinsic vacancies present in the undoped lattice are the most efficient since they can trap two electrons to gain electrical neutrality. However, as soon as Y(3+) ions are introduced in the system, those intrinsic vacancies migrate to Y-sites in next-nearest-neighbor locations, namely in a less efficient lattice location. This phenomenon is tentatively referred to as "delocalization" of vacancy sites. Moreover, the fact that Y-doped zirconia series presents quite similar CL spectra compared to the undoped zirconia could be an evidence that the radiative centers of undoped and Y-doped ZrO2 are basically the same. A fitting procedure has been made aiming to give a rational description of the variation of the spectra morphology, and a parameter able to describe the monoclinic to tetragonal phase transformation has been found. This parameter and the overall set of CL data enabled us to quantitatively assess polymorphic phase fractions by CL spectroscopy in the scanning electron microscope.

Position–sensitive electric property of flash–sintered 3Y–TZP ceramics based on DC bias assisted impedance analysis

Electrical and Hydrogen Reduction Enhances Kinetics in Doped Zirconia and Ceria: II. Mapping Electrode Polarization and Vacancy Condensation in YSZ

Electric field-induced grain boundary degradation mechanism in yttria stabilized zirconia

Mechanical behavior of ZrO2 ceramics in the post-flash stage

Thermally Stimulated Depolarization Processes in Zirconia Toughened Alumina Ceramics

Flash sintering incubation kinetics

Gas-discharge induced flash sintering of YSZ ceramics at room temperature

Key microstructural characteristics in flash sintered 3YSZ critical for enhanced sintering process

Dielectric Barrier Discharge Based Defect Engineering Method to Assist Flash Sintering

Mechanism analysis of arc-induced flash sintering of 3YSZ at room temperature

Flash Sintering of ZnO Ceramics at Room Temperature with Bisectional Electrode Distributions

Flash Sintering Of 8ysz Ceramics Under Ac Field

A simple optimized design of an electrode to conduct flash sintering at room temperature and low onset electric field

Effect of atmospheric conditions on the onset electric field of ZnO and Y<sub>2</sub>O<sub>3</sub> ceramics flash sintering at room temperature

Oxygen hole states in zirconia lattices: quantitative aspects of their cathodoluminescence emission.

Effects of electric field on microstructure evolution and defect formation in flash-sintered TiO2

Enhancing microstructure homogeneity and electrical conductivity in flash-sintered 8YSZ: Impact of electric-current ramp control and thermal insulation

Thermal Runaway, Flash Sintering and Asymmetrical Microstructural Development of ZnO and ZnO-Bi2O3 under Direct Currents

Role of oxygen vacancy on rapid densification and giant dielectric properties of flash sintered Ca2+ and Ta5+ co-doped TiO2 ceramics

Effect of atmospheric conditions on the onset electric field of ZnO and Y2O3 ceramics flash sintering at room temperature

Study of Deformation Mechanisms in Flash-Sintered Yttria-Stabilized Zirconia by In-Situ Micromechanical Testing at Elevated Temperatures