Abstract:The use of quartz is critical to the electron spin resonance (ESR) dating of sediments and fault gouges. The germanium center (Ge center) in quartz is a commonly used color center employed in ESR signal measurement. Although Ge center signals in quartz can be detected using an ESR spectrometer, they are weak and sometimes undetectable. Impurities in quartz grains can further aggravate these deficiencies and may even invalidate any attempt to repeat ESR ages due to the deficiencies evident in the processes used in sample preparation. Using sieving, carbonate-organic matter removal, water flotation, magnetic separation, heavy liquid separation, and HF solution etching, we separated quartz, feldspar (plagioclase), mica, and the heavy minerals and measured the ESR signal in each of them to examine the impact of impurities within mineral grains on the ESR signals. From the ESR spectra, we observed intense ESR signals in feldspar and the heavy minerals and weak signals in mica at the same positions as the Ge center in the quartz. The ESR signals in the feldspar proved to be the most intense and overrode the peaks exhibited by the Ge center in the quartz. Feldspar is commonly associated with quartz in sediments, but it is difficult to separate it from quartz as their colors, specific gravities, and magnetic properties are similar. Any ESR signal in quartz containing foreign minerals would therefore be likely to be heavily disturbed by the signals from these foreign minerals, particularly from the feldspar and heavy minerals. ESR signals in the feldspar decreased similarly to those in the quartz when exposed to sunlight, declining by 70%–80% after being exposed for 50 h. Such declination was more obvious in high-altitude areas than in low-altitude areas. Our results indicate that highly pure quartz is required when dating; we would therefore strongly suggest that the procedures for the purification of quartz grains should include floating, heavy liquid separation, and HF solution etching to remove the feldspar, heavy minerals, and any remnant magnetite. Such a procedure would guarantee that the signal that is measured comes from the quartz alone, allowing repeatable measurements using the same spectrometer as well as valid comparisons between the spectrometries derived from different spectrometers.

Thermal stability of the bleachable and unbleachable components of the ESR signals in sedimentary quartz

Atomic Investigation on the Facet‐Dependent Melting of Ceramic Nanostructures Via in Situ Electron Irradiation

Comparison of the Properties of Various Optically Stimulated Luminescence Signals from Potassium Feldspar

Testing the applicability of a partial bleach method for post-IR IRSL dating of Holocene-aged K-feldspar samples

Gamma radiation effects on quartz Al and Ti center electron spin resonance signal intensity: Implications for quartz provenance discrimination

Total-Ionizing-Dose Effects on Al/SiO2 Bimorph Electrothermal Microscanners

Variability in the thermal stability of OSL signal of single-grain quartz from the Nihewan Basin, North China

Purification of Quartz Via Low-Temperature Microwave Chlorinated Calcination Combined with Acid Leaching and its Mechanism

Application of multiple-centres ESR dating to middle Pleistocene fluviolacustrine sediments and insights into the dose underestimation from the Ti–H center at high equivalent doses

Optical bleaching and thermal stability of ESR signals in fault-related carbonates

The ESR Signals in Different Minerals and the Bleaching of Feldspar

Investigating Exchange Efficiencies of Sodium and Magnesium to Access Lithium from β-Spodumene and Li-Stuffed β-Quartz (γ-Spodumene)

Investigations on the Luminescence Properties of Quartz and Feldspars Extracted from Loess in the Canterbury Plains, New Zealand South Island

Structural evolution of water and hydroxyl groups during thermal, mechanical and chemical treatment of high purity natural quartz

Investigations of the Post-Ir IRSL Protocol Applied to Single K-feldspar Grains from Fluvial Sediment Samples

Assessment of Bleaching of K-feldspar Grains

Study Of Thermoluminescence Characteristics Of Quartz For High Radiation Doses (>1Kgy): Implications For Extending The Luminescence Dating Range

Optimization of the 'double Sar' Procedure for Polymineral Fine Grains

Thermal stability assessment of calcium monosulfoaluminate 12-hydrate by applying the in-situ X-ray diffraction method at 25–1250 °C

Bleachability of pIRIR signal from single-grain K-feldspar

Deposition Temperature and Thermal Annealing Effects on the Electrical Characteristics of Atomic Layer Deposited Al2O3 Films on Silicon