Abstract:Advanced Li-ion batteries adopting new cathode chemistries are required for the successful widespread transition to electric vehicles (EVs) and renewable energy sources, aiming for high energy density, long cycle life, and good rate capability. Commercial candidates for EV batteries include Ni-rich Li(Ni x Mn y Co 1−x-y )O 2 (NMC) cathodes, with Ni:Mn:Co ratios of 8:1:1 (NMC811) and higher. These are favored because of their high specific capacity (~ 200 mAh g -1 )and reduced cobalt content. Despite all of the advantages, these materials suffer from a range of degradation modes, many of which are associated with the redox and crystallographic behavior at high states of charge. In particular, Ni-rich cathodes suffer from several limitations, such as rapid capacity fade in comparison to NMC stoichiometries with lower Ni content. In addition, they also have a lower onset voltage for oxygen release and subsequent surface reconstruction leading to the formation of spinel and rock salt phases which impede (de)lithiation and therefore the achievable capacity of the cell. 1 Crystallographic properties of electrode materials are intrinsically linked to the electrochemical performance of the cell. NMC materials suffer from anisotropic changes in the crystal structure during cycling which induces strain and leads to issues such as crack formation, expediting degradation. One method to tackle capacity fade is to switch to single-crystal morphologies (particle size 1-3 μm) which have better mechanical stability than conventional polycrystalline morphologies (secondary agglomerate particles ~ 10 μm made up of primary particles which are 100 nm – 1 μm in size) and have less propensity to form extensive rock-salt layers. It is thought that the single-crystal morphology helps to reduce stress in the material as the anisotropic stress in polycrystalline cathodes is concentrated at grain boundaries. However, there is still a limited understanding of the subtle mechanistic differences between the two materials during cycling. 2 A multi-scale approach is required to gain a more comprehensive understanding of the degradation mechanisms at play and how they initiate and propagate. In this work, synchrotron diffraction methods were employed at the crystal, particle and cell scale using a variety of techniques including in-situ Bragg Coherent Diffraction Imaging (BCDI), 3D-XRD and operando high-resolution XRD. Intra-particle, inter-particle and electrode level heterogeneities were observed during cycling, both in pristine and aged samples. It is believed that these heterogeneities accelerate the loss of performance at the cell level by inducing crack formation which can then be observed in X-ray computed tomography data acquired in simultaneous lab studies. The overarching goal of these investigations is to add to the understanding of complex degradation mechanisms for Ni-rich layered transition metal oxide cathodes, ultimately aiding in the informed development of future battery electrode materials. References: 1] Xu, C. et al., Phase Behaviour during Electrochemical Cycling of Ni‐Rich Cathode Materials for Li‐Ion Batteries. Adv. Energy Mater. 2021, 11, 2003404. 2] Yin, S. et al., Fundamental and solutions of microcracks in Ni-rich layered oxide cathode materials of lithium-ion batteries. Nano Energy, 2021, 83, 105854.

Correlating Rate‐Dependent Transition Metal Dissolution between Structure Degradation in Li‐Rich Layered Oxides

Rate-dependent Electrochemical Reaction Mechanism of Spinel Metal Oxide Anode Studied by in Situ TEM

Correlation between regulated structure of Li-rich layered oxide and low-potential TM redox

High Cycling Rate‐Induced Irreversible TMO6 Slabs Glide in Co‐Free High‐Ni Layered Cathode Materials

Probing the Initiation of Voltage Decay in Li-rich Layered Cathode Materials at the Atomic Scale

Threshold for degradation

Origin of structural degradation in Li-rich layered oxide cathode

Oxygen loss and surface degradation during electrochemical cycling of lithium-ion battery cathode material LiMn2O4

Decoupling Capacity Fade and Voltage Decay of Li-rich Mn-rich Cathodes by Tailoring Surface Reconstruction Pathways

Revealing the degradation pathways of layered Li-rich oxide cathodes

A Critical Evaluation of Interfacial Stability in Li-excess Cation-disordered Rock-salt Oxide Cathode

Reaction inhomogeneity coupling with metal rearrangement triggers electrochemical degradation in lithium-rich layered cathode

Electronic origin of structural degradation in Li-rich transition metal oxides: The case of Li 2 MnO 3 and Li 2 RuO 3

Understanding Degradation at the Lithium-Ion Battery Cathode/Electrolyte Interface: Connecting Transition-Metal Dissolution Mechanisms to Electrolyte Composition

Understanding the Degradation Mechanisms of Lithium Ion Batteries Using in-Situ Multi-Scale Diffraction Techniques

Insight into the capacity degradation mechanism of LiNi0.5Co0.2Mn0.3O2 caused by rate-dependent kinetic limitations

Degradation and Structural Evolution Ofxli2mno3·(1–x)limn1/3ni1/3co1/3o2during Cycling

Regulating the Intralayer Cation Disorder in Layered Lithium-Rich Cathodes to Improve Cycle Performance.

A New Insight into Continuous Performance Decay Mechanism of Ni-rich Layered Oxide Cathode for High Energy Lithium Ion Batteries

Insight into the capacity decay mechanism of cycled LiNi 0.5 Co 0.2 Mn 0.3 O 2 cathodes via in situ x-ray diffraction

Unraveling the Correlation between the Synthesis Time and Electrochemical Performance of Transition Metal Layered Oxides by In Situ Neutron Powder Diffraction