Improved conductivity and piezoresistive properties of Ni-CNTs cement-based composites under magnetic field

Liyuan Liu,Jinxia Xu,Tianjiao Yin,Yang Wang,Hongqiang Chu

DOI: https://doi.org/10.1016/j.cemconcomp.2021.104089

IF: 9.93

2021-08-01

Cement and Concrete Composites

Abstract:A novel type of cement-based composite with preferentially orientated nickel-coated carbon nanotubes (Ni-CNTs) was fabricated by induction of magnetic field (MF) method for piezoresistive sensor in structural health monitoring system. The microstructures of Ni-CNTs and their aligned features in the as-fabricated composites were observed by scanning electron microscope (SEM), transmission electron microscopy (TEM), energy dispersive spectroscopy (EDS) and X-ray diffraction (XRD), respectively. The four-electrode method was applied to measure the conductivity and piezoresistive properties of as-fabricated composites. Besides, the effects of several influencing factors, including Ni-CNTs orientation and content, loading rate on the conductivity and piezoresistive properties of Ni-CNTs cement-based composites were determined. The results indicate that the CNTs coated with crystalline nickel are orientated preferentially along the MF direction, of which the orientation angles are concentrated between −30°-20°, presenting a Gaussian distribution. The conductivity and piezoresistive properties of oriented Ni-CNTs cement-based composites are anisotropic. The electrical resistivity and percolation threshold of composites have a sequence: perpendicular to MF > without MF > parallel to MF. Under cyclic compressive loading, Ni-CNTs cement-based composites parallel to MF direction exhibit the best piezoresistive properties. The optimum content level of CNT for the piezoresistivity is 1.20 vol%, which is slightly higher than the percolation threshold. Also, the strain sensitivity of composites parallel to MF is most sensitive to the loading rate.

construction & building technology,materials science, composites

What problem does this paper attempt to address?

The problem that this paper attempts to solve is how to prepare cement - based composites with nickel - coated carbon nanotubes (Ni - CNTs) having a preferred orientation by means of magnetic - field - induced methods, and to study the piezoresistive properties of these composites in structural health monitoring systems. Specifically, the paper focuses on the following aspects:

1. **Microstructure and Orientation Characteristics of Materials**: Observe Ni - CNTs and their orientation characteristics in composites by means of scanning electron microscopy (SEM), transmission electron microscopy (TEM), energy - dispersive spectroscopy (EDS) and X - ray diffraction (XRD).

2. **Conductivity and Piezoresistive Properties**: Measure the conductivity and piezoresistive properties of composites using the four - electrode method, and explore the influence of different factors (such as the orientation and content of Ni - CNTs, loading rate, etc.) on these properties.

3. **Performance Optimization**: Determine the optimal CNT content to achieve the best piezoresistive properties, and study the anisotropy of the conductivity and piezoresistive properties of composites in different directions (parallel to the magnetic field, perpendicular to the magnetic field and without a magnetic field).

The core objective of the paper is to improve the conductivity and piezoresistive properties of Ni - CNTs in cement - based composites through the preferred orientation induced by the magnetic field, so as to provide more effective sensing materials for structural health monitoring systems.