Abstract:Microfiltration plays an increasingly important role in various fields. Consequently, elucidating the mechanism of membrane fouling has emerged as a pivotal issue that needs to be resolved. In this study, a blocking filtration model was employed to evaluate the effects of membrane properties on the fouling mechanism during the microfiltration of representative polysaccharides, namely sodium alginate, pectin, and xanthan gum. Microfiltration membranes composed of hydrophilic and hydrophobic PVDF, mixed cellulose ester, as well as hydrophilic and hydrophobic PTFE were used as filter media. The flux decline behavior was significantly affected by the membrane properties, with hydrophilic membranes exhibiting a slower decrease in filtration rate. The model analysis revealed a correlation between the blocking characteristic values and the membrane properties. Although the blocking index n showed membrane material dependence, the values of this parameter remained consistent across various filtration conditions, including the wettability of the membrane surface, solute concentration, and pressure (pectin: n = 1.86, 1.85, 1.50, and 1.50 for hydrophilic PVDF, hydrophobic PVDF, hydrophilic PTFE, and hydrophobic PTFE, respectively). The resistance coefficient k was influenced by the characteristics of the membrane surface; the k values of the hydrophobic membranes were higher than those of the hydrophilic ones (pectin: k = 0.00084, 0.00725, 0.00714, and 0.0384 s1−n/cm2−n for hydrophilic PVDF, hydrophobic PVDF, hydrophilic PTFE, and hydrophobic PTFE, respectively). The model calculations, based on the values of n and k, demonstrated a relatively good agreement with the experimental data.

Dynamic behavior and mechanistic analysis in filtration of dilute particulate suspensions through nanofibrous membrane

Microscopic Mechanism Of Membrane Fouling In Micro-Filtration

The Effect of the Layered Internal Structure of Fibrous Beds on the Hydrodynamic Diffusive Behavior of Microparticles

Fouling mechanism of low-pressure hollow fiber membranes used in separating nanosized photocatalysts

Dynamic pore modulation of contracted carbon fiber filter for wastewater treatment: Filtration performance and in-situ regeneration mechanism

Effect of Support Material Properties on Dynamic Membrane Filtration Performance

Dynamic Monte Carlo Simulation of Protein-Membrane Interaction and Its Implication on Micro-Filtration Process

An Evaluation of the Relationship between Membrane Properties and the Fouling Mechanism Based on a Blocking Filtration Model

A Simple Method to Identify the Dominant Fouling Mechanisms during Membrane Filtration Based on Piecewise Multiple Linear Regression

Flow and fouling in elastic membrane filters with hierarchical branching pore morphology

Increasing particle concentration enhances particle penetration depth but slows down liquid imbibition in thin fibrous filters

Modeling of the Initial Deposition of Individual Particles During the Cross-Flow Membrane Filtration

Dead-End Flow Filtration of Solid Suspension in Polymer Fluid Through an Active Kaolin Dynamic Membrane

Nanostructured micrometric-pore membranes for nanofiltration: Micrometric geometry may optimize performance, energy efficiency and operational lifetime

Mechanistic insights of nanofillers tuning polymer microstructures for enhanced separation performance of nanofiltration membrane

Slip effect based bimodal nanofibrous membrane for high-efficiency and low-resistance air purification

Establishment and Mechanism Investigation of Partial Blocking Filtration Model of Microfiltration

Strain-Induced Nanocavitation in Block Copolymer Thin Films for High Performance Filtration Membranes

Effect of Membrane Pore Morphology on Microfiltration Organic Fouling: PTFE/PVDF Blend Membranes Compared with PVDF Membranes

Optimization on the performance of fibrous filter through computational fluid dynamic simulation coupled with response surface methodology

Membrane fouling and resistance analysis of dynamic membrane bioreactor