Abstract:Comprehension of wet particle behavior is of great importance in science and engineering. In the past two decades, modeling and simulation for wet particles have been extensively studied because of their various industrial applications. The discrete element method (DEM) is extensively employed to simulate the wet particle behavior. To calculate the wet particle behavior, several capillary force models have been developed so far. Roughly speaking, the capillary force models are classified into two types, namely, the analytical model and the geometrical approximation model. The analytical model is most frequently employed because of its simplicity, though only a small amount of the liquid volume is applicable. The geometrical approximation model has significant advantages because of no theoretical limitation of the liquid volume as well as its high accuracy. Incidentally, the geometrical approximation model usually expresses the liquid bridge shape by the toroidal approximation. However, validation tests for the geometrical approximation model have hardly been performed due to difficulty in incorporating the complex algorithm into the DEM. From the background, this paper aims to prove the superiority and adequacy of the geometrical approximation model in the DEM simulation for wet particles. First, the superiority of the geometrical approximation model to the analytical model is examined in a two-body system. Afterward, the following two types of validation tests are performed: granular collapse and wet powder mixing in a twin-screw kneader. In the granular collapse, the liquid content is set to be less than 4 vol. %. In the twin-screw kneader system, the liquid content is more than 5 vol. %. Through the validation tests, the adequacy of the geometrical approximation model in the DEM is proved because of the agreement between the computational and experimental results in the above systems. Consequently, this study will significantly contribute to a better understanding of wet particle behavior in science and engineering.

Inverse analysis of friction coefficient in discrete element method using powder properties by support vector regression

A multivariate regression parametric study on DEM input parameters of free-flowing and cohesive powders with experimental data-based validation

Studying on the Upper Limit of the Coarse-Grained DEM Model for Simulating Mixing Processes in a Rolling Drum with Complex Wall Boundary

Investigation of Modeling Non-Spherical Particles by Using Spherical Discrete Element Model with Rolling Friction

Numerical Research on Kerf Characteristics of Abrasive Waterjet Machining Based on the SPH-DEM-FEM Approach

Numerical Analysis of the Relationship between Friction Coefficient and Repose Angle of Blast Furnace Raw Materials by Discrete Element Method

Measurement and Simulation Validation of DEM Parameters of Pellet, Sinter and Coke Particles

Numerical modelling of suction filling using DEM/CFD

An experimentally validated DEM study of powder mixing in a paddle blade mixer

DEM simulation of the powder application in powder bed fusion

A Coupled DEM/CFD Analysis of Die Filling Process

The importance of a velocity-dependent friction coefficient in representing the flow behaviour of a blade-driven powder bed

Development of a DEM Method for Predicting Wear Distribution on Particle Scale

Validation study on a toroidal approximation-based capillary force model in the discrete element method simulation

A new method for DEM simulation of dust-bearing granular flow – Modeling the effect of dust on the change in granule friction coefficient

Discrete Element Method Simulation of Influence of Restitution Coefficient on Granular Kinetic Behaviors in Spout-fluid Bed

Prediction of coefficient of friction of solid powder lubricants under high pressure conditions using machine learning algorithmsVorhersage des Reibungskoeffizienten von Festpulverschmierstoffen unter Hochdruckbedingungen mit Hilfe von Algorithmen des maschinellen Lernens

Validation study on a coarse-grained DEM-CFD simulation in a bead mill

The Impact of Discrete Element Method Parameters on Realistic Representation of Spherical Particles in a Packed Bed

Modeling the powder compaction process by an integrated simulation and inverse optimization method

Discrete Element Simulation of the Effect of Roller-Spreading Parameters on Powder-Bed Density in Additive Manufacturing