Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

Aerodynamic noise reduction of a blunt flat plate by trailing-edge blowing

Active control of airfoil turbulent boundary layer noise with trailing-edge blowing

Noise Control of Blunt Flat-Plate Using Slit and Dielectric Barrier Discharge Plasma

Effects of Temperature on Drag Reduction in a Subsonic Turbulent Boundary Layer Via Micro-Blowing Array

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

A Numerical Study on the Flap Side-Edge Noise Reduction Using Passive Blowing Air Concept

Control of the noise production in a supersonic jet impinging an inclined plate using grooved surface

On the effect of velvet structures on trailing edge noise: experimental investigation and theoretical analysis

Influence of the liner-type treatment on the trailing-edge noise generated by a flat plate

Effects of Localized Micro-blowing on a Spatially Developing Flat Turbulent Boundary Layer

Aerodynamic noise from rigid trailing edges with finite porous extensions

Experimental investigation of active local blowing on the aerodynamic noise reduction of a circular cylinder

Airfoil Self-Noise Reduction by Gradient Distributed Porous Trailing Edges

An experimental study of tonal noise from a wind turbine airfoil with flat plate serrations

Effects of Throttling Orifice Plate on Flow and Aerodynamic Noise Characteristics Inside Valve Downstream

Aeroacoustic noise reduction by application of end plates on wall-mounted finite airfoils

The flow-induced structural vibration noise suppression mechanism of a wing–plate model by the junction suction and trailing edge blowing

Noise Reduction in Wind Turbine Airfoils with Serrated Trailing Edges: An Experimental Study in Low Turbulence Wind Tunnel

The Effects of the Orifice Plate Structure on the Aerodynamic Noise in the High Parameter Pressure Reducing Valve

Vortex–airfoil interaction noise control using virtual serrations and surface morphing generated by leading-edge blowing

Trailing-edge noise reduction through finlet-induced turbulence