Abstract:To overcome the environmental problems during manufacturing process, the twin-fluid atomization has been demonstrated as an efficient technique to reduce the lubri-cooling fluid consumption and its pollution emission. However, the coupling between the gas, liquid, and structure of the twin-fluid nozzle directly affect the droplet characteristics and size distribution, which has a significant effect on the processing performance. In the current work, the droplet characteristics during the collaborative atomization process of a twin-fluid nozzle with two kinds of atomizing cores are investigated and compared via a phase Doppler particle analyzer (PDPA), and the droplet diameter and size distribution of a new twin-fluid nozzle (NTN) with different atomizing cores are further investigated. The results reveal that the spray atomization characteristics and droplet size distribution are obviously influenced by the performance of primary and secondary atomization, which mainly depend on the atomizing core structure and the gas to liquid mass flow rate ratio (GLR). Because the gas acceleration performance of the new atomizing core is better than that of the standard atomizing core at the same GLR, compared with the standard twin-fluid nozzle (STN), the droplet diameter decreases by approximately 33.97%, the droplet number concentration and axial velocity increase by approximately 36.39% and 34.51%, respectively, and the spray cone angle of the STN is only approximately 80% of that of the NTN. Meanwhile, the higher GLR of the twin-fluid nozzle provides more energy for the droplets, so the viscous force between the liquids is easier to overcome and the atomization characteristics are improved. Nevertheless, for a smaller GLR, the droplet size distribution is significantly affected by the structural parameters of the NTN atomizing core due to the insufficient atomization power. Moreover, a smaller throat diameter, a smaller exit diameter, and a moderate distance between the liquid channel and the atomizing core exit are beneficial for improving the droplet cumulative distribution.

Effect of particle size distribution on the transmission efficiency of atomized water to the tracheal tube

Deposition of Droplets from the Trachea or Bronchus in the Respiratory Tract During Exhalation: A Steady-State Numerical Investigation

Research on the deposition efficiency of nanoparticles in human airways

Micron particle deposition in a tracheobronchial airway model under different breathing conditions

Spatial distribution and transient evolution of sub-droplet velocity and size in ultrasonic atomization

Study on Airflow and Inhaled Particle Deposition Within Realistic Human Upper Respiratory Tract

Effects of operating conditions on droplet deposition onto surface of atomization impinging spray

Theoretical Investigation of the Influence of Liquid Physical Properties on Effervescent Atomization Performance

EFFECTS OF LIQUID PROPERTIES ON DROP MEAN DIAMETER IN EFFERVESCENT ATOMIZATION SPRAY

Three-Dimensional Simulation Of Effervescent Atomization Spray

Research on deposition characteristics of on radioactive aerosols in a realistic human model

Numerical study on the deposition distribution and mechanism of inhaled drug particles in various regions of the realistic inhaler-airway model

Investigation of Ultrafine Particle Deposition in Human Airway to the 9th Generation of Bronchial Tubes Using Computational Fluid and Particle Dynamics

Effect of airflow rate on droplet deposition of an impinging-jet inhaler in the human respiratory tract

Numerical Simulation of Inhaled Aerosol Particle Deposition Within 3d Realistic Human Upper Respiratory Tract

Computational fluid dynamics simulation of full breathing cycle for aerosol deposition in trachea: Effect of breathing frequency

Effect of water supply pressure on atomization characteristics and dust-reduction efficiency of internal mixing air atomizing nozzle

Reducing the Diameter of the Atomized Particles by Coating Polymer Membrane on the Inner Wall of Micro-Tapered Holes of the Ultrasonic Mesh Atomizers

Experimental study on the atomization characteristics and dust removal efficiency of a fan-shaped nozzle for purifying working environment

An Experimental Study of Atomization Characteristics of the Ultrasonic Spray Nozzle

Investigation of the droplet characteristics and size distribution during the collaborative atomization process of a twin-fluid nozzle