Rapid Prototyping for Nanoparticle-Based Photonic Crystal Fiber Sensors

Michael Sherburne,Cameron Harjes,Benjamin Klitsner,Jonathan Gigax,Sergei Ivanov,Edl Schamiloglu,Jane Lehr

DOI: https://doi.org/10.3390/s24123707

IF: 3.9

2024-06-08

Sensors

Abstract:The advent of nanotechnology has motivated a revolution in the development of miniaturized sensors. Such sensors can be used for radiation detection, temperature sensing, radio-frequency sensing, strain sensing, and more. At the nanoscale, integrating the materials of interest into sensing platforms can be a common issue. One promising platform is photonic crystal fibers, which can draw in optically sensitive nanoparticles or have its optical properties changed by specialized nanomaterials. However, testing these sensors at scale is limited by the the need for specialized equipment to integrate these photonic crystal fibers into optical fiber systems. Having a method to enable rapid prototyping of new nanoparticle-based sensors in photonic crystal fibers would open up the field to a wider range of laboratories that could not have initially studied these materials in such a way before. This manuscript discusses the improved processes for cleaving, drawing, and rapidly integrating nanoparticle-based photonic crystal fibers into optical system setups. The method proposed in this manuscript achieved the following innovations: cleaving at a quality needed for nanoparticle integration could be done more reliably (≈100% acceptable cleaving yield versus ≈50% conventionally), nanoparticles could be drawn at scale through photonic crystal fibers in a safe manner (a method to draw multiple photonic crystal fibers at scale versus one fiber at a time), and the new photonic crystal fiber mount was able to be finely adjusted when increasing the optical coupling before inserting it into an optical system (before, expensive fusion splicing was the only other method).

engineering, electrical & electronic,instruments & instrumentation,chemistry, analytical

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the technical difficulties encountered during the rapid prototyping process of nanoparticle - based photonic crystal fiber sensors. Specifically, the paper focuses on the following aspects:

1. **High - quality cutting of photonic crystal fiber (PCF)** : Traditional cutting methods (such as using diamond blades) often lead to surface defects, which can clog the micro - channels in PCF and affect its performance. The paper proposes a new laser - cutting - plasma - cleaning (LCPC) method, which can ensure that a smooth and defect - free fiber end face is obtained for each cut, thereby increasing the success rate of cutting (from about 50% to 100%).

2. **Large - scale preparation of nanoparticle - filled PCF** : The traditional single - PCF filling method is inefficient and has potential safety hazards (for example, using vacuum suction may lead to the formation of liquid oxygen). The paper has developed a 3D - printed pressure adapter that can simultaneously fill multiple PCFs with nanoparticles, which not only improves efficiency but also ensures the safety of the operation.

3. **Rapid integration of PCF sensors** : Although the traditional fusion - splicing method is suitable for the final sensor fabrication, it is very time - consuming when different parameters need to be tested multiple times. The paper has designed a 3D - printed connector support structure that allows for rapid insertion and adjustment of PCF sensors, thereby greatly reducing the experimental preparation time and enabling researchers to more efficiently test the performance of various nanomaterial sensors.

Through these innovations, the paper aims to lower the production threshold of nanoparticle - based photonic crystal fiber sensors, making them applicable in more laboratories, thus promoting the research and development in this field.