Abstract:With the control parameters of the wall thickness of the ball table and the thickness of the pressure plate of the ball table, four universal wrapped assembled joint models were designed for the research of stress performance via static loading test. The failure mode of the joint, the axial force–displacement curve of the web member, the equivalent stress distribution of the ball table and the pressure plate of the ball table were analyzed, and the ABQAUS finite element software was used for the analysis of parameter expansion of the specimen. The research results show that the failure modes of universally wrapped assembled joints can be divided into the buckling failure of the ball table and the strength failure of the material. The wall thickness of the ball table is the key parameter affecting the failure mode of the joints, and the thickness of the pressure plate of the ball table is the crucial parameter influencing the ultimate bearing capacity of the joints. The maximum equivalent stress of the pressure plate and the ball table at compression zone for all the joints is occurred at the side squeezed by the bolt ball, and the growth rate of the equivalent stress for the ball table at compression zone is more uniform than that at tension zone. According to the finite element analysis results, when the wall thickness of the ball table is greater than 7 mm, the thickness of the pressure plate of the ball table is greater than 16 mm, the growth rate of the ultimate bearing capacity of the joint is significantly decreased, therefore, it is recommended to use the wall thickness of 7 mm and the pressure plate thickness of 16 mm in the actual design of the project.

Stiffness design, failure modes, and lightweight design of truss-lattice with filler sandwich plate under thermal loading

STIFFENER STIFFNESS AND ELASTIC BUCKLING STRESS OF STEEL PLATE SHEAR WALL

Yield surfaces and micro-failure mechanism of block lattice truss materials

Fabrication and mechanical behaviors of corrugated lattice truss composite sandwich panels

DEVELOPMENT OF LATTICE MATERIALS WITH HIGH SPECIFIC STIFFNESS AND STRENGTH

Truss and plate hybrid lattice structures: Simulation and experimental investigations of isotropy, large-strain deformation, and mechanisms

Mechanical and Self-Monitoring Behaviors of 3D Printing Smart Continuous Carbon Fiber-Thermoplastic Lattice Truss Sandwich Structure

Failure analysis of 1D lattice truss composite structure in uniaxial compression

Mechanical properties of a new type of plate–lattice structures

The Mechanical Properties Of Hierarchical Truss-Walled Lattice Materials

Mechanical Property of Lattice Truss Material in Sandwich Panel Including Strut Flexural Deformation

Design and analysis of light-weight lattice sandwich cylinders

A class of elastic isotropic plate lattice materials with near-isotropic yield stress

Foam-filling Techniques to Enhance Mechanical Behaviors of Woven Lattice Truss Sandwich Panels

Trussed concrete-filled steel tubular hybrid structures subjected to axial compression: Performance and design calculation

Two-level Homogenization and Multi-Failure Analyses of Hierarchical Lattice Stiffened Cylinder

A Novel Carbon Fiber Reinforced Lattice Truss Sandwich Cylinder: Fabrication and Experiments

Interlocked Hierarchical Lattice Materials Reinforced by Woven Textile Sandwich Composites

Trussed square concrete-filled steel tubular hybrid structures subjected to axial compression

Research on stress performance of universally wrapped assembled joints of lattice wind power tower with concrete-filled steel tube

Effective Stiffness of Rectangular Concrete Filled Steel Tubular Members