Abstract:A steel-wire wound reinforced thermoplastic pipe (SWW-RTP) has been widely utilized in many industrial areas, and a soil landslide is an inevitable hazardous extreme condition for the SWW-RTP as it is usually buried underground. It is imperative to study the mechanical failure behavior and the failure criterion of the SWW-RTP under the combination of internal pressure and soil landslide conditions, and this paper is the first study to investigate the topic. In this paper, groups of stress-strain curves of high-density polyethylene (HDPE) and steel wires were obtained by uniaxial tensile tests at different strain rates, with the help of a Digital Image Correlation device (DIC). A rate-dependent constitutive model was employed to represent the mechanical behavior of the HDPE and to help deduce the stress-strain curve of the HDPE under the required strain rate, estimated from the static simplification of the dynamic soil landslide. Afterwards, a finite element model of the SWW-RTP, embedded in a cubic of soil, was established with the software ABAQUS. The SWW-RTP model was composed of HDPE solid elements, embedded with steel-wire truss elements, and the soil was characterized with the extended Drucker-Prager model. A quartic polynomial displacement distribution was applied to the soil model to represent the soil landslide. Then, the mechanical response of the SWW-RTP was analyzed. It was found that the failure criterion of the HDPE yield was more suitable for the pipe subjected to internal pressure and soil landslide conditions, instead of the steel-wire strength failure criterion always used in traditional research on the SWW-RTP. Further, the influence of landslide width, internal pressure and steel-wire number were discussed. The larger the width of the landslide area, the gentler the deformation of the pipeline; this resulted in an increase in the maximum landslide and a decrease in the maximum curvature with the width of the landslide area. The relatively high internal pressure was beneficial to the safety of the SWW-RTP under landslide, because the internal pressure could increase the stiffness of the pipeline. The number of steel wires had a limited influence on the maximum landslide required for the SWW-RTP's failure. This work can be useful for the design and safe assessment of the SWW-RTP under internal pressure and soil landslide conditions.

Fracture failure of oil-collecting steel wire reinforced thermoplastic composite pipe

Investigation on Failure Mode of Short Carbon Fiber Reinforced Thermoplastic Composites Joints of Non-metallic Pipeline

Short-Term Mechanical Analysis of Polyethylene Pipe Reinforced by Winding Steel Wires Using Steel Wire Spiral Structural Finite Element Model

Failure analysis of a reinforced thermoplastic pipe used in an oil transportation system

Investigation of Interfacial Debonding Between Steel Wire and Adhesive Resin

Investigation on Crack Propagation Failure Modes of Short Carbon Fiber Reinforced Polyethylene Electrofusion Joints

Experimental and computational failure analysis of hydrogen embrittled steel cords in a reinforced thermoplastic composite pipe

Analysis of load carrying performance for glass fiber reinforced thermoplastic composite pipe under different in-service conditions

Experimental Investigation on Mechanical Properties of Plastic Pipes Reinforced by Cross Helically Steel Wires

Experimental Investigation on Mechanical Properties of Plastics Pipes Reinforced by Cross-winding Steel Wire

Study on Mechanical Failure Behavior of Steel-Wire Wound Reinforced Thermoplastic Pipe under Combined Internal Pressure and Soil Landslide Conditions

Analysis of the Mechanical Properties of a Reinforced Thermoplastic Composite Pipe Joint

Long-Term Stress Analysis of Plastic Pipe Reinforced by Cross-Winding Steel Wire

Study on steel wire reinforced thermoplastic pipes under combined internal pressure and bending moment at various temperatures

Thermal-Mechanical Fatigue Behavior of P92 T-Piece Pipe

Applicability Analysis of Thermoplastic Material As Liner Pipe for Trenchless Rehabilitation of Thermal Pipelines

Analyses on the Short-Term Mechanical Properties of Plastic Pipe Reinforced by Cross Helically Wound Steel Wires

Behaviour of steel wire-reinforced thermoplastic pipe under combined bending and internal pressure

Study on buried polyethylene pipe reinforced by steel wires under internal pressure and foundation settlement

Time-dependent response of thermoplastic matrix composite material under the cyclic loadings

Failure Analysis of Cracked P110 Repaired Tubing Used for Gas Transmission