Abstract:Although existing studies have emphasized the effects of micro-structured surfaces and vibration conditions on spray cooling efficiency. However, there is a research gap on how the coupling effect of these two factors affects spray cooling heat transfer. Therefore, in this study, the heat dissipation capacity of spray cooling under different vibration and microstructure size conditions is investigated experimentally using commercial HFE-649 as the coolant. The coolant is an electronic fluid with a global warming potential of only 1. Its low boiling point (49°C), which facilitates the early realisation of the phase change process, has a high potential for application in thermal management systems. The study reveals that both vibration and micro-structured surfaces significantly enhance the heat flux and heat transfer coefficient (HTC) in spray cooling. The combined effect of vibration and microstructures results in a more pronounced enhancement of cooling capacity, with the HTC increasing by 44% compared to a static smooth surface. As the vibration frequency and the side length ( w ) of the square fins on the micro-structured surface increase, the heat flux, HTC, critical heat flux (CHF), cooling efficiency, and heat transfer enhancement ratio (HTER) all show an increasing trend. However, at high vibration Reynolds numbers ( Rev ) (15708) and the w of the square fins of 0.8mm and 1.0mm, there is a notable decline in spray cooling capacity due to the excessively high Rev enhances the reciprocating motion of the liquid film, causing the film to inadequately spread and continuously accumulate around the edges. A correlation for heat dissipation capability of spray cooling under the coupled effects of vibration and micro-structured surfaces was derived and fitted, with the error in CHF within 12%.

Study on the influence of periodic contraction and expansion flow disturbance on convection heat transfer

The influence of active dynamic control flow vortexes on enhancing convective heat transfer

Study of laminar convection heat transfer in single-side-heating small-scale cooling channel with vibration cylinder

Study on the vertical oscillatory gas-liquid two-phase flow and heat transfer characteristics

Numerical study of periodical wall vibration effects on the heat transfer and fluid flow of internal turbulent flow

An improved vibration technique for enhancing temperature uniformity and heat transfer in viscous fluid flow

A novel method of enhancing convective heat transfer by dynamic controlling rib

Effect of vertical vibration on transient heat transfer characteristics of flow boiling in small rectangular channels

Numerical study on vibration heat transfer enhancement of multi-configured blunt-headed cylinder with fin device

THE EFFECTS OF WALL HEAT FLUX ARRANGEMENT ON FLOW INSTABILITY BOUNDARY IN A VERTICAL SINGLE TUBE

Investigating Enhanced Convection Heat Transfer in 3D Micro-Ribbed Tubes Using Inverse Problem Techniques

Experimental research on vibration-enhanced heat transfer of fin-tube vehicle radiator

Heat transfer and field synergy characteristics in a rectangular unit channel under mechanical vibration

Chaotic Behavior and Heat Transfer Analysis of Pulsating Flows with Different Frequencies

Experimental Study on Fluid Elastic Instability of Concentric Circular Arrangement Heat Exchanger Tubes

Experimental investigation of the effects of transverse vibration on the supercritical CO 2 heat transfer characteristics in horizontal tubes

New Idea of Heat Exchanger for Study of Flow-induced Vibration for Tube Arrays in Cross-flow

The Coupling Effect of Surface Vibration and Micro-structure on Spray Cooling Heat Transfer

Experimental Study on Convective Heat Transfer in Alternating Elliptical Axis Tubes

Numerical investigation of flow and heat transfer between concentric cylinders with slit wall

Experimental Study on the Effect of Trapezoidal-wave Disturbance Component on Enhanced Heat Transfer Efficiency of High-Viscosity Fluid