Abstract:The purpose of this investigation was to evaluate the microstructure, high-temperature oxidation behaviour, and hardness of a seal coating under controlled exposures at 750 °C with different exposure times. The results reveal that the main phases in the coating are Ni, FeNi3, and hexagonal BN, with α-Al2O3 peaks appearing after 2-h oxidation. As the exposure time increases, the diffraction peak intensity of α-Al2O3 begins to decrease and Cr2O3 peaks appear after 200 h. After 1000 h, Cr2O3 becomes dominant with only small amounts of α-Al2O3 remaining. The high-temperature oxidation process of the coating includes three stages: the fast stage, transition stage, and slow stage. The oxidation rate is constant in each stage, and in the fast stage and slow stages with values of 7.59 × 10−4 and 8.37 × 10−5 mg2·cm−4·s−1, respectively. Initially, α-Al2O3 forms near the pores in the coating, followed by the formation of Cr2O3. As the exposure time increases, oxidation penetrates into the interior of the coating along phase boundaries to form island-shaped inner oxide layers with high concentrations of Cr, Ni, and Fe. Additionally, hardness increases with increasing oxide percentage.<h3 class="a-plus-plus">Graphic abstract</h3>

Wettability and thermal shock resistance of novel h-BN based ceramic seals for nitrogen oxide sensor

Thermal Cycling Stability of Novel Hexagonal Boron Nitride (H-Bn)/glass Compressive Seals for Planar Intermediate Temperature Solid Oxide Fuel Cells

Enhanced thermal shock resistance of BN-based composites sintered by hot-pressing with the introduction of nano oxides

Thermal Shock Resistance of Si3N4/h-BN Composites Prepared Via Catalytic Reaction-Bonding Route

Improved thermal shock and oxidation resistance of β-SiAlON incorporated with h-BN

Effects of h‐BN on the thermal shock and oxidation resistance of SiO2‐bonded SiC refractories

Thermal Shock Behavior of Si3N4/BN Fibrous Monolithic Ceramics

Effect of BN content on microstructures, mechanical and dielectric properties of porous BN/Si3N4 composite ceramics prepared by gel casting

Effect of Boron Nitride Content on Mechanical、dielectric and Thermal Shock Resistance Properties of Si3N4-BN-MAS Composites

Thermal Shock Behavior of Si 3 N 4 /BN Fibrous Monolithic Ceramics.

Cyclic thermal shock resistance of h-BN composite ceramics with La2O3–Al2O3–SiO2 addition

Corrosion behaviour of NiCrFeAl-hBN seal coatings in oxidation environments at a high temperature

Thermal Shock Resistance of the Porous Boron Nitride/silicon Oxynitride Ceramic Composites

The Wettability and High-Temperature Properties of Porous BN/Si3N4 Ceramics Bonded with SiTi22 Filler

Cyclic thermal shock resistance of h-BN composite ceramics with La<sub>2</sub>O<sub>3</sub>-Al<sub>2</sub>O<sub>3</sub>-SiO<sub>2</sub> addition

Densification and comprehensive properties of h-BN-based refractories with in-situ formation of Y3Al5O12

Effect of h-BN on the mechanical and dielectric properties of porous h-BN/Si3N4 composite ceramics prepared by gel casting

Fabrication and properties of porous boron nitride/silicon oxynitride ceramic composites via gas pressure sintering

Bioinspired PcBN/hBN Fibrous Monolithic Ceramic: High-temperature Crack Resistance Responses and Self-Lubricating Performances

Interfacial compatibility and thermal cycle stability for glass-sealed oxygen sensors

High-temperature mechanical and thermal properties of h -BN/30vol%Y 2 SiO 5 composite