Abstract:High-accuracy, fast-response, and low-overshoot force control are important to guarantee the material removal accuracy and surface quality of robotic compliant grinding. In order to achieve the above target, this study develops an active compliant force-controlled end-effector based on a series elastic actuator for the robotic grinding of curved parts. Firstly, a decoupled robotic grinding system composed of an industrial robot and an end-effector is developed, and a novel force-controlled end-effector is designed by adding an elastic component between the servo motor and the load to improve compliance. Secondly, the influences of the elastic component and grinding tool stiffness on the stability of the force-controlled end-effector system are analyzed by establishing a contact model of the compliant end-effector and the transfer function of the entire force control system. Then, the stiffness of the grinding tool and the elastic component are optimized with full consideration of the system cutoff frequency and the end-effector compliance. To improve the force tracking accuracies of the developed compliant end-effector, a proportional-integral (PI) controller with first-order differential force feedforward control is designed. Finally, grinding experiments are conducted for verification. The effects of spring stiffness and grinding tool stiffness on the force control system are tested, which match well with the theoretical analysis. Grinding results show that the maximum force control error of the compliant force-controlled end-effector is decreased by 70% compared to that of the rigid force-controlled end-effector, and the overshoot of the force control is reduced from 30% to almost 0 under the same response speed. The maximum and average absolute grinding depth errors using the designed end-effector are reduced by 57.2% and 58.6%, respectively, compared with those of the traditional rigid end-effector, and the average surface roughness of the finished part is reduced by 19.2%. Which demonstrates the effectiveness and advantages of the proposed compliant force-controlled end-effector.

Design and Control of the Active Compliant End-Effector

An adaptive compliance position control based on EKF for series elastic actuation

A Review of End-Effector Research Based on Compliance Control

Design and Analysis of a Compliant End-Effector for Robotic Polishing Using Flexible Beams

Adaptive Impedance Control for Compliantly Actuated Robots with a Unified Safety Measure

Design and control of a compliant robotic actuator with parallel spring-damping transmission

Design and Optimization of Electromagnetically Driven End-Effector

Design and Control of a Passive Compliant Piezo-Actuated Micro-Gripper With Hybrid Flexure Hinges

Highly dynamic physical interaction for robotics: design and control of an active remote center of compliance

Flexure-based Environmental Compliance for High-speed Robotic Contact Tasks

Robotic compliant grinding of curved parts based on a designed active force-controlled end-effector with optimized series elastic component

Intelligent robotic impedance control using embedded system structure

Topology Optimization of a Compliant Constant-Force End Effector for Robotic Operations over Uneven Surfaces

Design and Kinematic Analysis of a Flexible-Link Parallel Mechanism With a Spatially Quasi-Translational End Effector

Modeling and force control of a pneumoelectric end-effector for robotic continuous contact operations

DEVELOPMENT AND ANALYSIS OF RECONFIGURABLE ROBOTIC END-EFFECTOR FOR MACHINING AND PART HANDLING

Design and Evaluation of a Compliant Quasi Direct Drive End-effector for Safe Robotic Ultrasound Imaging

Instrumented Compliant Wrist with Proximity and Contact Sensing for Close Robot Interaction Control

Compliant Control Technology of Manipulator

Adaptive Impedance-controlled Manipulator Based on Collision Detection

Compliance Control of Deburring Robots Based on Force Impedance