Abstract:Most traditional rigid grippers can cause damage to the surface of objects in actual production processes and are susceptible to factors such as different shapes, sizes, materials, and positions of the product. This article studies a flexible finger for flexible grippers, more commonly described as PneuNet, designs the structure of the finger, discusses the processing and manufacturing methods of the flexible finger, and prepares a physical model. The influence of structural parameters such as the thickness of the flexible finger and the angle of the air chamber on the bending performance of the finger was analyzed using the Abaqus simulation tool. An RBF-PID control algorithm was used to stabilize the internal air pressure of the flexible fingers. A flexible finger stabilization experimental platform was built to test the ultimate pressure, ultimate bending angle, and end contact force of the fingers, and the simulation results were experimentally verified. The results show that when the thickness of the flexible finger is 2 mm and the air chamber angle is 0 deg, the maximum bending angle of the flexible finger can reach about 136.3°. Under the same air pressure, the bending angle is inversely correlated with the air chamber angle and finger thickness. The experimental error of the bending angle does not exceed 3%, which is consistent with the simulation results as a whole. When the thickness is 2 mm, the maximum end contact force can reach about 1.32 N, and the end contact force decreases with the increase in the air chamber angle. The RBF-PID control algorithm used has improved response speed and a better control effect compared to traditional PID control algorithms. This article provides a clear reference for the application of flexible fingers and flexible grippers, and this research method can be applied to the analysis and design optimization of other soft brakes.

Design and Optimization of Electromagnetically Driven End-Effector

Design and Simulation Experiment of Rigid-Flexible Soft Humanoid Finger

Design and Control of an Electrohydraulic Soft Actuator System for Robotic Grippers

Electromechanical Model-Based Adaptive Control of Multilayered Dielectric Elastomer Bending Actuator

Fabrication and Modeling of Dielectric Elastomer Soft Actuator with 3D Printed Thermoplastic Frame

Structural Design and Control Performance Study of Flexible Finger Mechanisms for Robot End Effectors

Optimum Design For A Micromanipulation End-Effector Based On Flexure Hinge

A Novel Flexure-Based 3-DOF Micro-Parallel Manipulator with a Gripper for Micro/nano Manipulation

Design and Optimization of the Magnetic Field-Driven Spherical Gripper with Adjustable Stiffness

Design of a large stroke compliant gripping mechanism for constant-force applications

Design of Facile Dielectric Elastomer-Based Bending Module for Soft Robotics Applications

Development of a light-weight robot end-effector using polymeric piezoelectric bimorph

Optimized Dynamic Motion Performance for a 5-DoF Electromagnetic Manipulation

Design and analytical modeling of a double-joint flexible surgical instrument with hand-held isomorphic actuation

Towards higher load capacity: innovative design of a robotic hand with soft jointed structure

Design and analysis of a flexible robotic hand with soft fingers and a changeable palm

Novel soft robotic finger model driven by electrohydrodynamic (EHD) pump

Modeling and force control of a pneumoelectric end-effector for robotic continuous contact operations

Design and Control of the Active Compliant End-Effector

A Novel End-effector Finger Rehabilitation Robot (EFRR) for Stroke Patients

Design and Control of a Low-cost Non-backdrivable End-effector Upper Limb Rehabilitation Device