Abstract:Estimation of center of mass (CoM) and center of pressure (CoP) is critical for lower limb exoskeletons, prostheses, and legged robots. To meet the demand in these fields, this study presents a novel CoM and CoP estimation method for human walking through a wearable visual odometry (VO) device. This method is named VO-based estimation of CoM and CoP (VOECC). The methodology of VOECC is that the VO provides CoM trajectory estimation and the inherent walking dynamics model is exploited as prior knowledge for CoP trajectory estimation during human walking. Gait cycle is estimated based on the frequency analysis of the CoM trajectory, which is cropped into segments. Each segment mainly includes a half gait cycle. The segments are designed to be sliding to mitigate the disturbance of double-stance phase. For each segment, a quadratic programming (QP) problem is formulated to fit the CoM measurement with the theoretical walking dynamics model. The solution to this QP problem is an optimal gait parameters estimation, including CoP. Based on this solution, the human walking model with the CoM trajectory and CoP excursion is reconstructed. VOECC is evaluated experimentally where human walks on level ground and upstairs with VO device attached in front of the chest. The ground truth of CoM and CoP position is directly measured by the motion capture system and fully instrumented treadmill, respectively, and compared with the VOECC results. The proposed method is demonstrated to be effective in terms of wearable and extensible functionalities compared with the existing methods. Root-mean-squared errors between the CoP measured by fully instrumented treadmill and the CoP estimated by VOECC are evaluated and compared. This method has the potential to be extensible in lower limb rehabilitation, prosthetic, and legged locomotion fields. Note to Practitioners—This article addresses the problem of estimating center of mass (CoM) and center of pres-ure (CoP) trajectories using a minimum number of wearable sensors and reliable algorithms during human daily walking. Estimation of CoM and CoP trajectories is critical for lower limb exoskeletons, prostheses, and legged robots. In this study, a novel method named VO-based estimation of CoM and CoP (VOECC) is presented that utilizes a walking model as prior knowledge and integrates it with visual odometry data, which estimates the trajectory of the wearable visual device. Compared with the inertia measurement unit (IMU)-based method, VOECC only uses one wearable visual device and thus significantly reduces the cost and system complexity. In addition, the VOECC outperforms the motion capture system and force plate since it is not limited to space constraints and has the potential to be applicable for daily life locomotion tasks. VOECC is wearable and untethered and therefore can be directly amounted on lower limb exoskeletons, prostheses, and legged robots. In the experiments, motion capture system and force plates are used to measure CoM and CoP as ground truth to demonstrate the effectiveness of the proposed VOECC. Practical limitations include failure from fast turning and synchronization of multichannel sensors. These limitations will be addressed as our future research directions.

Development of a Low-Cost and Portable Walker-Based Human Motion Estimation System

The Identification Method for the Lower Limb Posture Based on the Identification and Trace of Image

Real-Time Human Pose Estimation on a Smart Walker using Convolutional Neural Networks

Development of a Low-Cost Markerless Optical Motion Capture System for Gait Analysis and Anthropometric Parameter Quantification

A Scalable and Wearable Self-Sensing IMU Sensor Network for Personalized Human Motion and Deformation Capture

Human Motion Capture Using Wireless Inertial Sensors

Displacement Estimation for Different Gait Patterns in Micro-Sensor Motion Capture

Development of a Non-Contacting Muscular Activity Measurement System for Evaluating Knee Extensors Training in Real-Time

Human Posture Detection Method Based on Wearable Devices

Biomechanical model-based displacement estimation in micro-sensor motion capture

Real-Time Human Motion Capture Based on Wearable Inertial Sensor Networks

Sensor network oriented human motion capture via wearable intelligent system

Wearable Leg Movement Monitoring System for High-Precision Real-Time Metabolic Energy Estimation and Motion Recognition

Wearable Sensors for 3D Upper Limb Motion Modeling and Ubiquitous Estimation

A smart walking stick for gait analysis of elderly and people with disabilities

WheelPoser: Sparse-IMU Based Body Pose Estimation for Wheelchair Users

Monocular 3D Human Pose Markerless Systems for Gait Assessment

Adaptive Threshold based ZUPT for Single IMU enabled Wearable Pedestrian Localization

Estimation of CoM and CoP Trajectories During Human Walking Based on a Wearable Visual Odometry Device

Estimating Lower Limb Kinematics Using a Reduced Wearable Sensor Count

A Potential-Real-Time Thigh Orientation Prediction Method Based on Two Shanks-Mounted IMUs and Its Clinical Application