Abstract:Active front-end (AFE) rectifiers have become widely employed in power systems to achieve unity power factor and harmonic mitigations. The typical modeling approaches applied for AFE rectifiers in the literature mostly relied on two baselines: the detailed model and the time-average model. The former approach deals with the switching element model (SEM), which leads to significant harmonics in currents with distorted waveforms. The latter approach uses the average-value model (AVM) to overcome the currents' harmonics as well as provide fast responses. However, even the AVM baseline has shown problems during the starting stage (lack of control signals) and over the dead-time periods, which causes serious issues in the implementation process. This paper presents an improved dynamic AVM for AFE rectifiers by precisely considering the issues mentioned above, along with the practical starting procedure and desirable initialization. The studied AFE rectifier is developed using the voltage-oriented control (VOC) technique based on the different modeling methodologies, including SEM, Conventional AVM, and the proposed AVM. The performance of all models is analyzed and compared using simulation results with MATLAB/Simulink R2023a Function blocks for all the algorithm parts and SimScape elements for the electrical circuit model. The simulation results illustrate that the performance of the proposed AVM approach can closely resemble the behavior of the SEM baseline with low harmonic distortion. To evaluate the performance of the proposed model, several case studies are investigated to verify the AFE rectifier operation, regarding mostly the total harmonic distortion (THD) wherein the THD percentages are improved to 4.78 and 2.5 from 5.14 and 2.78 for low- and high-power loads, respectively.

Voltage Injection based MPDPC Technique for Individual Phase Loss Reduction in Active Front-End Rectifier

A Modified DPWM with Neutral Point Voltage Balance Capability for Three-Phase Vienna Rectifiers

Model Predictive Based Direct Power Control Method Using Switching State Preference for Independent Phase Loss Decrease of Three-Phase Pulsewidth Modulation (PWM) Rectifiers

High-Efficient Direct Power Control Scheme Using Predictive Virtual Flux for Three-Phase Active Rectifiers

An Improved Power-Decoupling Scheme with Grid Inductor Phase-Shift Modification for Single-Phase Converter

An Improved Modulation Strategy for the Active Voltage Clamping HERIC Inverter

A Multiplexing Modulation Strategy Based On Single-Phase Ac/Dc Converter With Optimized E-Capless Function

Direct Power Control of DFIG System Without Phase-Locked Loop under Unbalanced and Harmonically Distorted Voltage

Power Compensated Triple-Vector Model Predictive Direct Power Control Strategy for Non-Redundant Fault-Tolerant Rectifiers

Efficient Model-Free Predictive Power Control for Active Front-End Modular Multilevel Converter

Improved Three-Vector Based Dead-Beat Model Predictive Direct Power Control Strategy for Grid-Connected Inverters.

Mode Predictive Direct Power Control Scheme with Fixed Operation Frequency for a Vienna Rectifier Based on Voltage‐Sensorless

Active Thermal Management Method for Output-Parallel DAB DC–DC Converters under Parameter Mismatches and Asymmetrical Modulation

Improved Dynamic Performance of Average-Value Modelled Active Front-End Rectifiers

Dynamic performance optimization for high-power density three-phase Vienna PFC rectifier

Multi-level Transient Modeling of the Aeronautic Asymmetric 18-Pulse Phase-shifting Auto-transformer Rectifier in Full-cycle Design

Model Predictive Virtual Flux Control Method for Low Switching Loss Performance in Three-Phase AC/DC Pulse-width-Modulated Converters

Model Predictive Control Strategy Based on Loss Equalization for Three-Level ANPC Inverters

A Loss Redistribution Technique for the Power Devices in the NPC Converter by PWM Zero-Sequence Injection

A Novel Power Decoupling Control Method to Eliminate the Double Line Frequency Ripple of Two Stage Single-Phase DC-AC Power Conversion Systems

Digitized Feedforward Compensation Method for High Power Density Three-Phase VIENNA PFC Converter