Abstract:The development of techniques to probe interfacial molecular transport is important for understanding and optimizing surface-based analytical methods including surface-enhanced spectroscopies, biological assays, and chemical separations. Single-molecule-fluorescence imaging and tracking has been used to measure lateral diffusion rates of fluorescent molecules at surfaces, but the technique is limited to the study of slower diffusion, where molecules must remain relatively stationary during acquisition of an image in order to build up sufficient intensity in a spot to detect and localize the molecule. Although faster time resolution can be achieved by fluorescence-correlation spectroscopy (FCS), where intensity fluctuations in a small spot are related to the motions of molecules on the surface, long-lived adsorption events arising from surface inhomogeneity can overwhelm the correlation measurement and mask the surface diffusion of the moving population. Here, we exploit a combination of these two techniques, imaging-FCS, for measurement of fast interfacial transport at a model chromatographic surface. This is accomplished by rapid imaging of the surface using an electron-multiplied-charged-coupled-device (CCD) camera, while limiting the acquisition to a small area on the camera to allow fast framing rates. The total intensity from the sampled region is autocorrelated to determine surface diffusion rates of molecules with millisecond time resolution. The technique allows electronic control over the acquisition region, which can be used to avoid strong adsorption sites and thus minimize their contribution to the measured autocorrelation decay and to vary the acquisition area to resolve surface diffusion from adsorption and desorption kinetics. As proof of concept, imaging-FCS was used to measure surface diffusion rates, interfacial populations, and adsorption-desorption rates of 1,1'-dioctadecyl-3,3,3'3'-tetramethylindocarbocyanine (DiI) on planar C18- and C1-modified surfaces.

Optical Imaging and Tracking of Single Molecules in Ultrahigh Vacuum

Imaging Single Molecules and Direct Observation of Single Molecule Reaction at A Solid-Liquid Interface

Illuminating Single Molecules in Condensed Matter

Tracking Brownian motion in three dimensions and characterization of individual nanoparticles using a fiber-based high-finesse microcavity

Tracking the ultrafast motion of a single molecule by femtosecond orbital imaging

Probing Liquid Surfaces under Vacuum Using SEM and ToF-SIMS.

Simultaneous tracking of ultrafast surface and gas-phase dynamics in solid-gas interfacial reactions

Single-shot imaging of surface molecular ionization in nanosystems

Integration of Conventional Surface Science Techniques with Surface-Sensitive Azimuthal and Polarization Dependent Femtosecond-Resolved Sum Frequency Generation Spectroscopy

Label-Free Optical Imaging of the Dynamic Stick-Slip and Migration of Single Sub-100-nm Surface Nanobubbles: A Superlocalization Approach.

A molecular beam-surface apparatus for quantum state-resolved adsorption studies

Direct Observation of Single-Molecule Generation at a Solid-Liquid Interface

Ultrafast Isolated Molecule Imaging Without Crystallization.

Tracking Interfacial Dynamics of a Single Nanoparticle Using Plasmonic Scattering Interferometry

Optical Imaging of Surface Chemistry and Dynamics in Confinement

Ultrafast Imaging of Molecular Dynamics Using Ultrafast Low-Frequency Lasers, X-ray Free Electron Lasers, and Electron Pulses

Simultaneous tracking of ultrafast surface and gas-phase dynamics in solid–gas interfacial reactions

Direct detection of single molecules by optical absorption

Diffractive imaging of a molecular rotational wavepacket with femtosecond Megaelectronvolt electron pulses

Room-Temperature Single-Molecule Infrared Imaging and Spectroscopy through Bond-Selective Fluorescence

Imaging fluorescence-correlation spectroscopy for measuring fast surface diffusion at liquid/solid interfaces