Abstract:Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, Ahead of Print. The bending stiffness, torsional stiffness, and low-order modal frequencies of the body-in-white (BIW) are crucial factors in structural lightweight design. This paper introduces a BIW optimization approach for electric vehicles (BEVs) that integrates comprehensive sensitivity analysis and multi-parameter similarity models. The aim is to efficiently balance the BIW's stiffness performance with minimal weight, while also managing potential manufacturing cost increases from design modifications. Firstly, the validity of the computational model is demonstrated by the BIW bending and torsion stiffness test and modal test. On this basis, the integrated sensitivity evaluation indexes of the structural member thickness parameters to the stiffness, weight and low-order modal frequency response of the BIW were calculated. The sheet metal thickness parameters of 17 structural members were preferred as design variables, and a multi-parameter similarity prediction model for BIW weight reduction design was constructed. Minimum weight, maximum stiffness and higher modal frequency of the BIW are defined as the optimization objectives. The optimal solution was finally solved using a multi-objective optimization algorithm. The results indicate a 1.582% reduction in weight of the BIW compared to the pre-optimization BIW. This paper delves into the intricate interplay between the parameters of the BIW's structural components using simulation optimization techniques alongside experimental validation. This study not only proposes a new idea for the problem of how to efficiently and accurately determine the best optimization object from a large number of structural components in the development of vehicle structural safety, but also provides a research basis for automobile manufacturers to implement further weight reduction and optimization work on the BIW at the later stage of BEV development.

Single- and Multi-material-Based Design of Lightweight Vehicle Body

Lightweight design of multi-material body structure based on material selection method and implicit parametric modeling

Integrated lightweight optimization design of wall thickness, material, and performance of automobile body side structure

Weight reduction design of multi-material vehicle components using level set-based topology optimization

A performance-driven lightweight optimization method for material-structure coupling design of cab

Multi-disciplinary design optimisation considered fluid-structure interaction and life prediction applied in the lightweight carbody structure

Lightweight design of electric bus roof structure using multi-material topology optimisation

Multi-parameter similarity model-based lightweight design of battery electric vehicle body-in-white

Finite element analysis study: Topology optimization for the front lower arm with innovative double and complex phase materials

Multi-objective Collaborative Optimization for the Lightweight Design of an Electric Bus Body Frame

Material Selection for Lightweight Design of Vehicle Component

Lightweight design of an electric bus body structure with analytical target cascading

Cross-section optimization of vehicle body through multi-objective intelligence adaptive optimization algorithm

Optimized Design of Lightweight Structure with Spare Wheel Fixed below Rear Floor

Multidisciplinary Design and Collaborative Optimization for Bus Body

Parametric design and modeling method of CFRP laminated components applicable for multi-material vehicle body development

Lightweight design of bus frames from multi-material topology optimization to cross-sectional size optimization

Study on Lightweight of Vehicle Body Structure Based on Implicit Parametric Model

Structure–connection–performance integration lightweight optimisation design of multi-material automotive body skeleton

Towards composite suspension control arm: Conceptual design, structural analysis, laminate optimization, manufacturing, and experimental testing

Multi‐Disciplinary Design Optimization of a Composite Car Door for Structural Performance, NVH, Crashworthiness, Durability and Manufacturability