Abstract:The deformation of an elastic rod under the unilateral constraint of a cylinder was discussed as a simplified model of the coiling process of an element of extendable space mast in astronautic technique. The process from a straight rod to a helical rod,at last to connected planar rings is a spatial large deforma- tion of the rod.Therefore the hypothesis of small deformation cannot be applied in analysis.Considering the existence of constraint force,the Kirchhoff equations of a rod without distributed force cannot be ap- plied too.The nonlinear differential equations of equilibrium of a rod constrained by a cylinder were estab- lished with Euler angles as attitude variables of the cross section.Some first integrals were applied to de- termine the internal forces and torques.Assume that the coiling process is slowly and the inertial effects are neglected.Consequently the helical configuration with continuously variable parameters can be treated as the quasi-equilibrium state in the coiling process.The necessary axial compressive force and torque in the coiling process were derived as the functions of the pitching angle of helix.The stability of the helical rod in coiling process was analyzed in first approximation.It is shown that the stability conditions cannot be satisfied when the rod has hinged constraints on both ends and the relative twist is restricted to zero. The stable helical equilibrium in whole coiling process can be realized only when the relative twist of the rod is admissible by the constraints.The necessary compressive force and torque to ensure the stability of coiling process were suggested.

Counting the coils in cylindrical helical compression springs: A clarification note

Supporting Information Breakdown of Hooke’s Law at Nanoscale – 2D Materials-based Nanospring

Influence of coil contact on static behavior of helical compression springs

Finite element analysis and experimental study of spiral flexure spring

Effective Computational Model for Determining the Geometry of the Transition Zone of End Coils of Machined Springs, Enabling Efficient Use of the Spring Material

Enhanced formulae for determining the axial behavior of cylindrical extension springs

Modeling and dynamics analysis of helical spring under compression using a curved beam element with consideration on contact between its coils

Stiffness and Strength Analysis of Composite Cylindrical Helical Springs

DYNAMIC STIFFNESS FORMULATION, FREE VIBRATION AND WAVE MOTION OF HELICAL SPRINGS

A STUDY ON THE STRESS DISTRIBUTION IN COIL WRAPPING AND ITS EFFECT ON FINAL COIL DEFORMATION

Static Stiffness Prediction Theory and Simulation of CFRP Cylindrical Coil Spring

Optimal Design of Helical Springs of Power Law Materials

Practical fatigue strength diagrams for compression springs based on the FKM-Guideline "Analytic strength Assessment for Springs"

Design and analysis method of nonlinear helical springs using a combining technique: Finite element analysis, constrained Latin hypercube sampling and genetic programming

Coil Motion Effects in Watt Balances: a Theoretical Check

THEORETICAL AND NUMERICAL ANALYSIS OF COILABLE SPACE MAST IN COILING PROCESS

Enhanced compression performance of an improved rectangular helical spring incorporated support feature

General Equations of a Helical Spring With a Cup Damper and Static Verification

Mechanical Analysis of Coiling Process of an Elastic Rod

Study on stiffness measurement of spring tube based on Hertzian contact theory

An Equivalent Axisymmetric Modeling Approach for Circumferential Springs under Large Deformation Based on Mechanical Anisotropy