Lack of Fusion in Additive Manufacturing: Defect or Asset?

Jenniffer Bustillos,Jinyeon Kim,Atieh Moridi

DOI: https://doi.org/10.48550/arXiv.2104.07014

2021-04-14

Materials Science

Abstract:Rapid cooling rates and stochastic interactions between the heat source and feedstock in additive manufacturing (AM) result in strong anisotropy and process-induced defects deteriorating the tensile ductility and fatigue resistance of printed parts. We show that by deliberately introducing a high density of lack of fusion (LoF) defects, a processing regime that has been avoided so far, followed by pressure assisted heat treatment, we can print Ti-6Al-4V with reduced texture and exceptional properties surpassing that of wrought, cast, forged, annealed, and solution-treated and aged counterparts. Such improvement is achieved through the formation of low aspect ratio {\alpha}-grains around LoF defects upon healing, surrounded by {\alpha}-laths. This occurrence is attributed to surface energy reduction and recrystallization events taking place during healing of LoF defects. Our approach to design duplex microstructures is applicable to a wide range of AM processes and alloys and can be used in the design of damage tolerant microstructures.