A comprehensive combustion, performance, and environmental analyses of algae biofuel, hydrogen gas, and nano-sized particles (liquid-gas-solid mix) in agricultural CRDI engines

Harish Venu,Tiong Sieh Kiong,Manzoore Elahi M. Soudagar,N.M. Razali,S. Ramesh,Yasser Fouad,Armin Rajabi,Prabhu Appavu,V. Dhana Raju,Ibham Veza,Lingesan Subrmani,M.A. Kalam,Ümit Ağbulut
DOI: https://doi.org/10.1016/j.ijhydene.2024.05.209
IF: 7.2
2024-06-16
International Journal of Hydrogen Energy
Abstract:The present research encompasses the utilization of TiO 2 nano particles with enrichment of H 2 (10 lpm) with Chlorella Emersonii Methyl Ester (CEME) on an agricultural-based CRDI engine. CEME20 (20% chlorella emersonii methyl ester blended with 80% mineral diesel) is employed for the tests. The nanoparticle concentration is limited to 50 ppm which has been considered according to O 2 concentration in biodiesel. Experimentation revealed that, with hydrogen gas and TiO 2 nanoparticles, the BTE and BSFC were improved significantly. At full load conditions, BTE is enlarged by 7.3%. In addition, there is a simultaneous decrease in HC and CO emissions (by about 36.3 and 40.9% respectively) for algal biofuel blends, while NO x emissions increased by 27.3% with respect to mineral diesel. 5.1% and 6.5% increase in combustion characteristics (79.8 bar combustion pressure and 89.2 J/°CA heat release rate)were observed for the CEME/H 2 /TiO 2 blend which could be attributed to effective combustion of hydrogen and catalytic combustion activity provided by TiO 2 nano additives. CEME/H 2 /TiO 2 blend recorded maximum Mass Fraction burnt (MFB) (74.7%) as well as lowered PSD (Particle size Diameter) profile (34.8 nm @ 0.29 E+08 dN/dlogDp (#/cm 3 )) at full engine load condition indicating the presence of H 2 and nano additives which has influence over the combustion.
energy & fuels,electrochemistry,chemistry, physical
What problem does this paper attempt to address?