Abstract:Microbial electrochemical system (MES) was an emerging technology for synchronous power generation and pollution removal. During current generation, the COD removal performance of air-cathode MES fed with domestic wastewater was greatly enhanced, compared with the condition absent of current. Based on the simulation of first-order kinetics, the COD removal rate was investigated with the increasing of current densities from 0 to 1.61 ± 0.13 A m−2 by external resistances regulation. In this process, the overall COD removal kinetics constants were increased by 110% from 0.075 ± 0.005 to 0.157 ± 0.010 h−1. The background COD reduction unrelated to current generation was greatly stimulated by the initial rising of current density (from 0 to 0.273 ± 0.003 A m−2) and then limited by the substrate competition with exoelectrogens. The effluent with low COD concentration was found to restrict the power output of downstream anodes with a COD limit level of 200 mg L−1 and SCOD of 120 mg L−1. In MES, only a small fraction (< 3.8%) of energy could be harvest as electricity. Nevertheless, very little energy (< 7.2%) from reduced COD was used for biomass synthesis, while most of the reduced COD was mineralized by microbial metabolism. The MES was observed a low sludge yield of 0.028 ± 0.006 g-sludge g−1-COD with a sludge retention time of 30 days. Therefore, the low sludge yield and electron-flow-assisted COD removal should be recognized as the two main advantages of MES rather than power generation in wastewater treatment.

What problem does this paper attempt to address?

The problem that this paper attempts to solve is to use the microbial electrochemical system (MES) to assist in the removal of chemical oxygen demand (COD) in wastewater through electron flow under continuous flow conditions. Specifically, the research aims to: 1. **Improve COD removal efficiency**: By adjusting the external resistance to increase the current density, the researchers explored the influence of current density on the COD removal rate, especially the change in the COD removal rate during the process when the current density increased from 0 to 1.61 ± 0.13 A m\(^{-2}\). 2. **Optimize the hydraulic retention time (HRT)**: The researchers adjusted the hydraulic retention time (from 0.5 to 6 hours) and explored the influence of different HRTs on the COD removal effect to find the optimal HRT, so that the downstream module can still maintain a high power output when treating wastewater with a low COD concentration. 3. **Analyze the relationship between background COD removal and electrochemical activities**: The study distinguished COD removal (\(\Delta\)COD\(_{\text{cur}}\)) caused by the external circuit current from background COD removal (\(\Delta\)COD\(_{\text{bas}}\)), and explored the relationship between the two and their trends with the change of current density. 4. **Evaluate sludge production**: The study also focused on the amount of sludge produced by the MES system during wastewater treatment, especially the characteristics of the sludge production rate (28 mg g\(^{-1}\)-COD) and the low sludge production rate (7%), which indicates that MES has an advantage in reducing sludge production. 5. **Energy and material balance**: By calculating the energy input and output and the amount of COD removed under different operating conditions, the researchers evaluated the overall performance of the MES system, especially its performance under open - circuit conditions, low - current conditions, maximum - power generation and high - current conditions. In summary, the main objective of this paper is to explore and optimize the ability of the MES system to treat wastewater under continuous - flow conditions through experimental and theoretical analysis, especially to improve the COD removal efficiency through electron - flow assistance, and to evaluate its feasibility and advantages in practical applications.

Electron flow assisted COD removal in wastewater under continuous flow conditions using microbial electrochemical system

Effects of High Ammonia Loading and In-Situ Short-Cut Nitrification in Low Carbon‑nitrogen Ratio Wastewater Treatment by Biocathode Microbial Electrochemical System.

The operation characters of biocathode microbial electrochemical system with microbial separator for domestic wastewater treatment: Power generation, long-term stability, and organic removal

Discerning realizable advantages of microbial electrochemical system towards raw municipal wastewater treatment: From the analyses of mass and energy flow

A Novel Microbial Electrolysis Cell (MEC) Reactor for Biological Sulfate-Rich Wastewater Treatment Using Intermittent Supply of Electric Field

Electrochemical Regulation on the Metabolism of Anode Biofilms under Persistent Exogenous Bacteria Interference

Enhanced Microbial Electrochemical Systems Performance by Optimizing the “Anode-Collector” Collection Mode: from Enhancement Mechanism to Construction Strategy

Enhanced performance and microbial interactions of shallow wetland bed coupling with functional biocathode microbial electrochemical system (MES)

Power density of microbial electrochemical system responds to mass transfer characters of non–ion–selective microbial separator

Potential of Novel Wastewater Treatment System Featuring Microbial Fuel Cell to Generate Electricity and Remove Pollutants

Long-term operation of cathode-enhanced ecological floating bed coupled with microbial electrochemical system for urban surface water remediation: From lab-scale research to engineering application

Conductive Materials on Biocathodes Altered the Electron-Transfer Paths and Modulated Γ-Hch Dechlorination and CH4 Production in Microbial Electrochemical Systems

Optimization of Bioelectricity Generation in Constructed Wetland-Coupled Microbial Fuel Cell Systems

Improving Electricity Generation and Substrate Removal of a MFC–SBR System Through Optimization of COD Loading Distribution

A microbial electrochemical hybrid system for simultaneous sludge treatment, acid production, and desalination

Domestic wastewater treatment towards reuse by "self-supplied" microbial electrochemical system assisted UV/H2O2 process

Combining metal-microbe and microbe-microbe dual direct electron transfer on Fe(0)-cathode of bio-electrochemical system to enhance anaerobic digestion of cellulose wastewater

The Effect of Fl Ow Modes and Electrode Combinations on the Performance of a Multiple Module Microbial Fuel Cell Installed at Wastewater Treatment Plant

[Electricity generation performance of two-chamber microbial full cell in the treatment of simulated wastewater]

Simultaneous deep removal of nitrate and tetrabromobisphenol A in microbial electrochemical system-constructed wetland

Microbial Water Electrolysis Cells for Efficient Wastewater Treatment and H2 Production