Abstract:Organic–inorganic hybrid perovskite solar cells (PSCs) are presently gaining significant attention owing to their high conversion efficiencies achieved in recent years. However, poor long-term stability against water and defects at film surfaces and grain boundaries are important factors causing performance degradation and rapid loss of the photovoltaic response. To remedy this, a pyridine derivative with long C–F chains (PFAD) is synthesized and employed as a passivator to reduce the trap states of perovskite and promote better humidity stability via antisolvent properties. The results demonstrate that the trap states of perovskite could be minimized by the presence of pyridinic nitrogen and then the formation of coordination bonds with undercoordinated Pb2+ ions. The resulting carrier recombination time is prolonged and verified via photoluminescence. The power conversion efficiency (PCE) of the PFAD-passivated perovskite solar cell increased to 20.48%, with practical elimination of hysteresis due to the high quality of the perovskite films. The significant gain generated via PFAD modification supports further applications in thin-film optoelectronic devices. Moreover, PFAD-modified devices exhibit enhanced humidity stability due to the protection of hydrophobic C–F chains from moisture; the PCE decreased about 15% after 30 days of exposure in a moisture ambient condition. Our work provides a promising strategy to further improve the performance and stability of perovskite solar cells by designing bifunctional organic molecules with passivation and hydrophobic effects.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsaem.1c01295.XPS spectra of perovskite and PFAD-modified perovskite; XRD patterns of perovskite films at different PFAD concentrations; J–V curves and PCE distributions of the control and PFAD-modified perovskite solar cells; and performance of perovskite solar cells at different PFAD concentrations (PDF)This article has not yet been cited by other publications.

An investigation of the impact of nafion polymer on surface passivation and analysis of degradation in HIT solar cells for improvement performance

Surface Passivation Studies of n-type Crystalline Silicon for HIT Solar Cells

Stable passivation of cut edges in encapsulated n-type silicon solar cells using Nafion polymer

HIT Solar Cell with V20x Window Layer

Improving Solar Cell Efficiency of Silicon and Silicon Tandem Structure by Using Surface Modification

Study of the Preparation and Photocatalytic Activities of Nafion/TiO2 Hybrid Membrane

In-depth Understanding the Effect of Electron-Withdrawing/-donating Groups on the Interfacial Carrier Dynamics in Naphthalimide-Treated Perovskite Solar Cells

Boosting the proton conductivity, chemical stability, and fuel cell performance of nafion membrane at high operating temperatures and low humidity levels by incorporating phytic acid

AFORS-HET-based numerical exploration of tunnel oxide passivated contact solar cells incorporating n- and p-type silicon substrates

Accelerated damp-heat testing at the cell-level of bifacial silicon HJT, PERC and TOPCon solar cells using sodium chloride

Development of High-Performance Polymer Electrolyte Membranes through the Application of Quantum Dot Coatings to Nafion Membranes

Dual-side interfacial passivation of FAPbI3 perovskite film by Naphthylmethylammonium iodide for highly efficient and stable perovskite solar cells

PEDOT:PSS-Nafion/n-Si Hybrid Heterojunction TOPCon Solar Cells: Experiment and Simulation

Enhancing industrialization TOPCon solar cell efficiency via comprehensive anti-reflection passivation film optimization

Surface Passivation with a Fluorocarbon-Based Pyridine Derivative for High-Crystallinity Perovskite Solar Cells with Efficiency Over 20% and Good Humidity Stability

Surface Modification of Heterojunction with Intrinsic Thin Layer Solar Cell Electrode with Organosilane

Balance of efficiency and stability of silicon heterojunction solar cells

High-Mobility Hydrogenated Fluorine-Doped Indium Oxide Film for Passivating Contacts c-Si Solar Cells

CHEMICAL DEGRADATION OF NAFION MEMBRANES UNDER PEMFC AS INVESTIGATED BY DFT METHOD

Tuning Back Side Passivation for Enhancing the Performance of PERC Solar Cells

Polyamide-coated Nafion Composite Membranes with Reduced Hydrogen Crossover Produced Via Interfacial Polymerization