Abstract:The ongoing development of the space-based laser interferometer missions is aiming at unprecedented gravitational wave detections in the millihertz frequency band. The spaceborne nature of the experimental setups leads to a degree of subtlety regarding the otherwise overwhelming laser frequency noise. The cancellation of the latter is accomplished through the time-delay interferometry technique. Moreover, to eventually achieve the desired noise level, the phase fluctuations of the onboard ultrastable oscillator must also be suppressed. This can be fulfilled by introducing sideband signals which, in turn, give rise to an improved cancellation scheme accounting for the clock-jitter noise. Nonetheless, for certain Sagnac-type interferometry layouts, it can be shown that resultant residual clock noise found in the literature can be further improved. In this regard, we propose refined cancellation combinations for two specific clock noise patterns. This is achieved by employing the so-called geometric time-delay interferometry interpretation. It is shown that for specific Sagnac combinations, the residual noise diminishes significantly to attain the experimentally acceptable sensitivity level. Moreover, we argue that the derived combination, in addition to the existing ones in the literature, furnishes a general-purpose cancellation scheme that serves for arbitrary time-delay interferometry combinations. The subsequential residual noise will only involve factors proportional to the commutators between the delay operators. Our arguments reside in the form of the clock noise expressed in terms of the coefficients of the generating set of the first module of syzygies, the linear combination of which originally constitutes the very solution for laser noise reduction.

Note: A new method for directly reducing the sampling jitter noise of the digital phasemeter.

An Improved Phase Locking Method with Real-Time Phase Feedback Assisted by Pilot-Tone

Automatic amplitude control for phasemeter of spaceborne laser interferometry

The Development of Phasemeter for Taiji Space Gravitational Wave Detection

Refined Clock Jitter Reduction in the Sagnac Type Time Delay Interferometry Combinations

A New Method for Gravitational Wave Detection with Atomic Sensors

A low-noise analog frontend design for the Taiji phasemeter prototype.

Study on TPD Phasemeter to Suppress Low-Frequency Amplitude Fluctuation and Improve Fast-Acquiring Range for GW Detection

A phasemeter concept for space applications that integrates an autonomous signal acquisition stage based on the discrete wavelet transform.

Method to reduce excess noise of a detuned cavity for application in KAGRA

Reduction of noise due to scattered light in gravitational wave antennae by modulating the phase of the laser light

Suppression of Subpixel Jitter in Resonant Scanning Systems With Phase-locked Sampling

Squeezing the quantum noise of a gravitational-wave detector below the standard quantum limit

Dual balanced readout for scattered light noise mitigation in Michelson interferometers

Limits to the sensitivity of a low noise compact atomic gravimeter

Multi-frequency signal acquisition and phase measurement in space gravitational wave detection

Subtraction of temperature induced phase noise in the LISA frequency band

Reduction of transient noise artifacts in gravitational-wave data using deep learning

Clock noise evaluation of space-based gravitational wave detectors based on time-delay interferometry

Beat-Notes Acquisition of Laser Heterodyne Interference Signal for Space Gravitational Wave Detection

Simulation Analysis of Phase Jitter in Differential Sampling of AC Waveforms Based on the Programmable Josephson Voltage Standard