Abstract:A low-noise single-frequency laser is a key component of the space-based gravitational wave detector, and the intensity noise of the laser directly affects the sensitivity of the space-based GW detector. In this work, we report a low-noise single-frequency laser designed for space-based gravitational wave detector. The laser is based on a master oscillator power amplifier (MOPA), which is designed to possess a low-power, narrow-linewidth seed laser acting as master oscillator (MO) and an all polarization-maintaining fiber amplifier acting as power amplifier (PA). The amplifier that uses a robust mechanical design consists of an Yb-doped double-clad fiber forward pumped by wavelength-locked 976 nm pump laser diode (LD) to achieve 2.13 W of output power and 70 dB of signal-noise ratio (SNR). To suppress the relative intensity noise (RIN) in a millhertz regime (1 mHz–1 Hz), we characterize the power stabilization of a pump diode laser based on a proportional-integral-derivative (PID) feedback control loop where an in-loop photodetector is used. The power fluctuation can be converted into the fluctuation of the current signal by the photodiode, the current signal is converted into the voltage signal and amplified by a transimpedance circuit. Then, the voltage signal is compared with the voltage reference signal, and the error signal is achieved to adjust real-timely the drive current of the pump laser diode. This is a good way to significantly suppress the RIN of a laser at low frequencies, but the measured RIN below 4 mHz is still higher than –60 dBc/Hz. In order to further suppress the RIN to lower than 4 mHz, an active precise temperature control technology is used to suppress the thermal noise from pump LD and fiber coupler. To assess the RIN milliertz regime, we design an RIN measurement system consisting of a high-precision signal acquisition card (24 bit) and a computer program based on LabVIEW. The measurement range of the system is 2 μHz–102.4 kHz and the frequency resolution up to 2 µHz, much better than the counterparts of commercial instruments. By stabilizing the fiber amplifier pump LD current and the temperature of pump LD and the temperature of fiber coupler, the out-of-loop RINs are measured to be –63.4 dBc/Hz@1 mHz and –105.8 dBc/Hz@1 Hz , and in a milliertz regime of 1 mHz–1 Hz, the RIN is below –60 dBc/Hz. The results show that the feedback control of the fiber amplifier pump LD current and the temperature control of the key devices can effectively suppress the RIN in the millihertz frequency band, which lays a foundation for further improving the intensity noise performance in the low frequency band.

Automatic amplitude control for phasemeter of spaceborne laser interferometry

Anti Light Disturbance Analysis of the Measurement of High Precision micro Displacement

Study on TPD Phasemeter to Suppress Low-Frequency Amplitude Fluctuation and Improve Fast-Acquiring Range for GW Detection

Multi-frequency signal acquisition and phase measurement in space gravitational wave detection

Utilizing multi-point temperature sensing to evaluate the low frequency noise of phasemeter for intersatellite laser interferometer

The Development of Phasemeter for Taiji Space Gravitational Wave Detection

Laser Interferometric Multi-Degree-of-Freedom Measurement Technology in Space Gravitational-Wave Detection

Beat-Notes Acquisition of Laser Heterodyne Interference Signal for Space Gravitational Wave Detection

Clock noise evaluation of space-based gravitational wave detectors based on time-delay interferometry

Experimental scheme and noise analysis of weak-light phase locked loop for large-scale intersatellite laser interferometer

An Improved Phase Locking Method with Real-Time Phase Feedback Assisted by Pilot-Tone

Millihertz Band Low-Intensity-noise Single-Frequency Laser for Space Gravitational Wave Detection

Proof-of-principle Experimental Demonstration of Time-delay-interferometry for Chinese Space-borne Gravitational Wave Detection Missions

Experimental demonstration of constant amplitude modulation heterodyne interferometry

Constant amplitude modulation heterodyne interferometry

Analysis of Telescope Wavefront Aberration and Optical Path Stability in Space Gravitational Wave Detection

Residual Amplitude Modulation in Interferometric Gravitational Wave Detectors

Note: A new method for directly reducing the sampling jitter noise of the digital phasemeter.

Suppression of Clock-Jitter Noise and Laser Phase Noise in Arm Locking

Readout for intersatellite laser interferometry: Measuring low frequency phase fluctuations of high-frequency signals with microradian precision

Phasemeter core for intersatellite laser heterodyne interferometry: modelling, simulations and experiments