Abstract:International Journal of Structural Stability and Dynamics, Ahead of Print. Given the increasing use of high-strength steels in building constructions, the stability design of high-strength steel beams has become a crucial consideration. However, the current standards of various countries are based on analyses and fittings derived from conventional steel, rendering them unsuitable for high-strength steel. Moreover, existing research indicates that these standards underestimate the ultimate load-bearing capacity of high-strength steel beams. A finite element model was established to investigate lateral torsional buckling in high-strength steel beams. The obtained results were then compared with test results from experiments conducted on Q460GJ and Q690 steel beams. The reliability and accuracy of the established finite element model were validated. Through parametric studies, the impact of depth-to-width ratio, boundary condition, and steel grade on the stability coefficient was evaluated. It was observed that at the same non-dimensional slenderness, an increase in the depth-to-width ratio or a reduction in support constraints led to a decrease in the stability coefficient. It should be noted that the steel grade had little effect on the stability coefficient. Comparisons with the current steel structure design codes, such as EN1993-1-1, GB50017-2017, JGJ/T483-2020, and ANSI/AISC360-22 revealed an underestimation of the stability coefficient for clamped high-strength steel beams under uniformly distributed loads. Based on finite element simulations, stability coefficients for high-strength Q460, Q690, and Q960 clamped beams were determined. Similar to the stability coefficient proposed in GB50017-2017 for the lateral buckling stability design of steel beams, a lateral buckling stability coefficient for high-strength steel clamped beams subjected to uniformly distributed loads was proposed.

Advanced line-finite-element for lateral-torsional buckling of beams with torsion and warping restraints

A Ductility-Centred Analytical Model for Axially Restrained Double-Span Steel Beam Systems Subjected to Sudden Columns Loss

A Multi-Spring Component Modelling Approach for T-Stub Connections

Critical Load for Shear-Induced Lateral-Distortional Buckling in I-section Steel Beams Considering Flexural Stiffness Ratio

Lateral Buckling of Web-Tapered I-beams: A New Theory

Inelastic Storey-Buckling Factor of Steel Frames

A unified analysis for distortional and lateral buckling of C-purlins in flexure

Shear Lag Including Axial Balance of Box Beams by Finite Segment Model

Global Buckling Prevention of Reduced-Core-length Buckling-Restrained Braces: Theoretical and Numerical Investigations

Numerical Investigations on Elastic Buckling and Hysteretic Behavior of Steel Angles Assembled Buckling-Restrained Braces

Optimal design of steel buckling-restrained braces considering stiffness and strength requirements

An Improved and Robust Finite Element Model for Simulation of Thin-Walled Steel Bolted Connections

Nonlinear Model for LTB Prediction of RHS Beams Under Combined Axial and Bending Loads With Distortional Deformation Allowed

Tension-Flange Restraint Effect on Lateral-Torsional Buckling Moment Capacity of Web-Tapered Steel I-Sections

Flexural Response of Axially Restricted RC Beams: Numerical and Theoretical Study

Experiments and numerical modelling of cold-formed steel beams under bending and torsion

Stainless steel lipped C-section beams: Numerical modelling and development of design rules

Lateral-torsional Buckling Resistance of Aluminium I-beams

Nonlinear Finite Element Analysis Of Improved Steel Beam-Column Connections

Numerical Study and Design Method for Lateral Torsional Buckling of High-Strength Steel Beams

Experimental and numerical investigation on flexural-torsional buckling of Q460 steel beams