The effect of extractives on water-vapor sorption by wood

Frederick F. Wangaard,Luis A. Granados

DOI: https://doi.org/10.1007/bf00349758

1967-01-01

Wood Science and Technology

Abstract:The woods of different species vary widely in the nature and amount of their extractive content with a resultant variation in their sorption characteristics. This is particularly evident in the case of tropical woods, many of which are characterized by high extractive content. The nine species included in this study ranged from 3... 17 percent in extractive content. As determined from their desorption isotherms these species ranged from 20.5... 32.8 percent in fiber saturation point prior to extraction, and from 30.4... 38.0 percent after the removal of extractives with a series of neutral solvents. An analysis of variance showed that the variation in fiber saturation point among these species was reduced by about one-half following extraction in desorption and by approximately 7/8 in adsorption.The results of this study lead to several conclusions.The principal effect of extractives is to depress the sigmoid isotherm in the upper range of relative humidity, typically above 60 ... 70 percent. Isotherms of extracted and unextracted wood coincide very closely at relative humidities below about 60 percent.Based on these nine species, the increase in fiber saturation point resulting from the removal of extractives is greatest for a species with a low initial fiber saturation point and least for a species with a high initial fiber saturation point. Model equations accounted for 68 percent of the increase in desorption and 78 percent of the increase in adsorption. The remaining variance is presumed to be due to differences in chemical composition and physical organization of the skeletal cell wall.By employing the Hailwood-Horrobin model equation in analyzing the data, it was possible to partition the sorbed moisture as monomolecular and polymolecular sorption. The presence of extractives has very little effect on the amount of moisture sorbed as a monolayer on the internal surfaces of the cell wall (Langmuir sorption). In contrast, the sorption of moisture in polymolecular layers is reduced in greatly varying degree consistent with the theory of bulking action whereby the extractive substance within the cell wall precludes moisture from occuping the same space.By means of a regression analysis of monomolecular moisture vs. the constant M (a measure of the availability of bonding sites for sorption) in the Hailwood-Horrobin equation, it is evident that monolayer sorption increases with increased availability of bonding sites in both unextracted and extracted wood. By similar analysis polymolecular sorption also increases with increased surface activity in the case of extracted wood, but this effect is completely masked in the analysis of unextracted wood by the predominant bulking action. Total sorption, dominated by polymolecular sorption, shows similar relationships. Only in the case of essentially extractive-free wood can total sorption be expected to reflect the availability of molecular sorption sites and hence reveal variations in degree of crystallinity, cell wall compactness, or chemical composition to a significant degree.

materials science, paper & wood,forestry