Abstract:Thermo-sensitive polyurethane (TSPU) solution containing varying concentration of in situ-generated TiO2 nanoparticles was successfully prepared via an organic–inorganic hybrid technique, and the final nanocomposite membranes were formed via solution casting. Depending on the membrane formation temperature (Tmf) during casting, completely-opposite gas transport behaviors of the TSPU nanocomposite membranes were observed. When Tmf was lower than the melting point (Tm) of soft segment (PCL10000) in the TSPU, gas permeability coefficients of the nanocomposite membranes were found to increase significantly with increasing nano-TiO2 concentration. Conventional composite theory failed to explain such observation because filler particles are generally considered to create more tortuous diffusion path in the polymer for penetrants, and should thereby lead to a systematic reduction in gas permeability. This counter-intuitive phenomenon was then rationalized by postulating that rigid TSPU chain could not pack efficiently around the TiO2 nanoparticles during solvent evaporation, which resulted in polymer layer with higher free volume at the interface than the bulk polymer regions. Evidences supporting such presumption were provided by (1) density measurement that found negative deviation of actual densities of TSPU nanocomposite membranes from theoretical prediction; (2) positron annihilation lifetime spectroscopy that demonstrated increased free-volume size and concentration within TSPU upon the in situ generation of TiO2 nanoparticles. However, when Tmf was elevated above the Tm of the soft segment, flexible TSPU chain seemed able to pack around the TiO2 nanoparticles as efficiently as in the bulk polymer. In this case, gas transport behavior of the TSPU nanocomposite membranes followed the prediction of conventional composite theory.

Permeation and photo-induced outgassing of deuterium in hollow glass microspheres doped with titanium

P-doped TiO_2 Immobilized Diatomite and Its Photocatalytic Performance under Visible Light

Effect of Surface Erosion on Permeability of Hollow Glass Microspheres

Investigating the Intermediate Water Feature of Hydrated Titanium Containing Bioactive Glass

Effect of the P/Ti Ratio on the Visible-Light Photocatalytic Activity of P-Doped Tio2

Influence of wall thickness and filling gas procedure on permeability of hollow glass microsphere

Effect of titanium ion doping on γ-ray shielding, structure and dielectric characteristics of glasses made of barium zinc borate

Enhanced UV Photoactivity of Ti3+ Self-Doped Anatase TiO2 Single Crystals Hydrothermally Synthesized Using Ti-H2O2-HF Reactants

Effect of Ti/P ratio on structure, crystallization behaviour and photocatalytic activity of MgO–TiO2–P2O5–Al2O3–SiO2 glass-ceramics

High hydrogen isotopes permeation resistance in (TiVAlCrZr)O multi-component metal oxide glass coating

Interaction of Atomic Deuterium with Rutile TiO2(011)-(2×1)

Effect of pre-deformation on hydrogen diffusion and hydrogen induced damage in commercially pure titanium

Effect of porosity on deuterium retention in titanium thin film

Helium bubbles in Gd 2 Ti 2 O 7 borosilicate glass-ceramic composites

Investigation on effects of tritium release behavior in Li4SiO4 pebbles

Microstructural and photocatatlytic properties of Eu-doped mesporous titanium dioxide nanopaticles by sol-gel method

Effect of Titania Dopant on Optical Performance of Silica Glass

Gas-driven Permeation of Deuterium Through Tungsten with Different Microstructures

Membrane Formation Temperature-Dependent Gas Transport Through Thermo-Sensitive Polyurethane Containing in Situ-Generated TiO2 Nanoparticles

Hydrogen desorption performance of Ti-mediated MgH2 and Mg2 NiH4

Improving hydrogen isotope permeation resistance of (TiVAlCrZr)O multi-component metal oxide coating by O + Ion implantation