Abstract:When the grain size is below a critical value, the deformation mechanism of nanocrystalline (NC) metal shifts from dislocation- to grain boundaries (GBs)-mediated activities. However, GB activities including deformation and rotation in the elastic and plastic stages have not given detailed analysis because of the limitation of current experimental techniques, as well as the unrealistic model with regular boundaries in most molecular dynamics (MD) simulation reducing the activities. To quantitatively analyze GB activities, we recently developed an algorithm based on moving least-squares interpolant. Besides, the phase field model was used to build the nanocrystalline (NC) Cu with more natural GBs for MD tensile simulation. The results of temperature dependence of Young's modulus (E), strain rate sensitivity (SRS), and variation of stress at GBs (σGB) and at grain interiors (σGI) are in good agreement with previous researches. In the elastic stage, the σGB fluctuates in a larger range than σGI. The vibrated σGB is the results of micro-elastic and micro-plastic deformation of GBs and the increased stage of σGB in one cycle can lead to increasing the σGI. Thus, the temperature dependence of E is affected by the frequency of vibrated σGB at relative low temperatures (T ≤ 450 K). The E is strain rate independent because of the same vibration of σGB. In the plastic stage, the flow stress strongly depends on the size of twinning boundaries (TBs) structures. The fraction of GB activities improves with increasing temperature and decreasing strain rate. GB activities can attenuate stress concentration on boundaries and then results in the formation and growth mechanism of TB changing from Shockley partial dislocation gliding on adjacent plane of stacking faults (SFs) to GB deformation. Thus, the size of TB at low temperatures and high strain rate is larger than that at the opposite conditions.

MESOMECHANICAL ANALYSIS OF THE TENSILE DEFORMATION OF PURE COPPER BICRYSTAL

Advanced Numerical Characterization of Mono-Crystalline Copper with Defects

Exploration of the Defect’s Effect on the Mechanical Properties of Different Orientated Nanowires

MD Investigations for Mechanical Properties of Copper Nanowires with and Without Surface Defects

An investigation of slip transmission during uniaxial tensile deformation of a coarse-grained copper via EBSD characterization and crystal plasticity modelling

PLASTICITY THEORY ANALYSIS OF GRAIN ORIENTATION EVOLUTION OF POLYCRYSTALLINE COPPER DURING UNIAXIAL COMPRESSION

Research on Deforming Mechanism of Nanocrystalline Cu Thin Film under Contact Deformation

Identification of active slip modes in twinned bicrystals of GNS/Cu composite through intragranular misorientation axes analysis

Molecular dynamics simulation on mechanisms of plastic anisotropy in nanotwinned polycrystalline copper with {111} texture during tensile deformation

A mesoscale investigation of strain rate effect on dynamic deformation of single-crystal copper

Study on the Micro-Deformation Evolution Properties of Copper Bicrystals by Digital Speckle Correlation Metrology

Strain localization and ductile fracture mechanism of micro/mesoscale deformation in ultrafine-grained pure copper

Molecular Dynamics Study on the Nano-Void Growth and Coalescence at Grain Boundary

Influence of grain boundary activites on elastic and plastic deformation of nanocrystalline Cu as studied by phase filed and atomistic simulaiton

Grain Coarsening in Nanocrystalline Copper with Very Small Grain Size During Tensile Deformation

Effects of crystallographic orientations and grain boundaries on nanoscratching behaviour of unique bi-crystal Cu

Atomistic Simulations of Tension Properties for Bi-Crystal Copper with Twist Grain Boundary

Investigations on the deformation behavior of polycrystalline Cu nanowires and some factors affecting the modulus and yield strength

The Study on Microscopic Mechanical Property of Polycrystalline with SEM Moiré Method

In-situ EBSD study of deformation behavior of nickel-based superalloys during uniaxial tensile tests

Effect of grain boundary deformation on mechanical properties in nanocrystalline Cu film investigated by using phase field and molecular dynamics simulation methods