Abstract:Fossil fuel boilers typically produce high-temperature process heating due to the impossibility of current renewable technologies. Vapour compression heat pump systems have been proposed up to 200 °C with subcritical cycles. To increase the heating production level, this paper proposes heating up to 250 °C through a transcritical high-temperature heat pump (THTHP) using R1336mzz(Z), which is not thermally degraded till this temperature, according to existing data. Computational models of a transcritical vapor compression cycle with and without an internal heat exchanger are developed for this work. The input cycle parameters, such as evaporation, production temperature, gas cooler output temperature, and the superheating degree, have been modified through iteration to consider possible scenarios in different industrial sectors. Moreover, the impact of using waste heat to increase evaporation temperature or superheating degree has been studied to optimize the cycle. The internal heat exchanger has also been considered for superheating the compressor suction. Other relevant parameters, such as compression ratio or volumetric mass flow rate, have also been assessed. The results show that a heat pump is feasible to reach 250 °C temperature using waste heat at 120 °C (evaporation at 100 °C and 20 °C of superheating degree), reaching a COP of 3.3. The variation of evaporator temperature from 80 °C to 140 °C increases COP from 2.5 to 5.9, while the increase of superheating degree from 20 °C to 100 °C increases COP from 3.2 to 7. Waste heat use optimization proves that it is more efficient to prioritize the increase of the evaporation temperature. If the industry requires lower production temperatures, the COP can reach a value of 7.0 at 180 °C. The decrease in gas cooler outlet temperature impacts less the COP than other input parameters. At baseline conditions, an optimum superheating degree with an internal heat exchanger of 45 K produces a maximum COP of 4.0. THTHP emissions are less than gas boilers for the same application, and in countries with greener electricity generation, these emissions can be 50 times lower.

Thermodynamic analysis and heat exchanger calculations of transcritical high-temperature heat pumps

A thermodynamic analysis of a transcritical cycle with refrigerant mixture R32/R290 for a small heat pump water heater

Refrigerants And Heat Pumps For Efficient Use Of Low Grade Thermal Energy

Theoretical Analyses of a New Two-Stage Absorption-Transcritical Hybrid Refrigeration System

Thermodynamic Analysis on a Two-Stage Transcritical CO2 Heat Pump Cycle with Double Ejectors

Transcritical-transcritical cascade CO2 heat pump cycles for high-temperature heating: A numerical evaluation

Thermodynamic analysis of a dual-pressure evaporation high-temperature heat pump with low GWP zeotropic mixtures for steam generation

Thermodynamic analysis of cascade high-temperature heat pump using new natural zeotropic refrigerant mixtures: R744/R600 and R744/R601

Towards sustainable process heating at 250 °C: Modeling and optimization of an R1336mzz(Z) transcritical High-Temperature heat pump

Energy, Exergy, Economic and Environmental Studies on a Nonflammable Eco-Friendly Mixture for Efficient Heating in Cold Regions

Performance Investigation on a Novel Air-Source Heat Pump Using CO2/HC for Recirculated Water Heater in Cold Regions

Experimental and Theoretical Assessments on the Systematic Performance of a Single-Stage Air-Source Heat Pump Using Ternary Mixture in Cold Regions

Thermodynamic analysis of novel mixtures including siloxanes and cyclic hydrocarbons for high-temperature heat pumps

Experiments of advanced centrifugal heat pump with supply temperature up to 100 °C using low-GWP refrigerant R1233zd(E)

Significant thermal upgrade via cascade high temperature heat pump with low GWP working fluids

Analysis of a New Super High Temperature Hybrid Absorption-Compression Heat Pump Cycle

High-temperature and transcritical heat pump cycles and advancements: A review

Thermodynamic and Economic Analysis of a High Temperature Cascade Heat Pump System for Steam Generation

High-glide refrigerant blends in high-temperature heat pumps: Part 1 – Coefficient of performance

Energy and exergy analysis of the heat pump cycle using working fluids with low environmental impact

Theoretical Performance Analysis of an Ejector Enhanced High-Temperature Heat Pump with Dual-Pressure Condensation and Evaporation