Polyacrylonitrile‐based porous polymer spheres and their conversion to N‐doped carbon materials for adsorption and electrocatalysis

Zhuo Gao,Ignacio Sanjuán,Ulrich Hagemann,Alexandra S. M. Wittmar,Corina Andronescu,Mathias Ulbricht
DOI: https://doi.org/10.1002/app.55438
IF: 3
2024-03-30
Journal of Applied Polymer Science
Abstract:Preparation of porous polyacrylonitrile and carbon spheres as well as evaluation of performance in adsorption and electrocatalysis. Because of their tunable porosity and specific surface area, porous materials are of high interest for the purification of wastewater by adsorption as well as in electrocatalysis, where, in particular, developing metal‐free carbon‐based catalysts for the oxygen reduction reaction (ORR) is researched. The carbon spheres presented here can meet these two requirements simultaneously. Porous polyacrylonitrile (PAN) spheres were firstly prepared by droplet shaping cum nonsolvent induced phase separation. Then, they were converted to nitrogen‐doped carbon spheres by two‐step carbonization via preoxidation and pyrolysis. During the pyrolysis step, carbon dioxide was used to reopen the pores of the materials that had been blocked after the preoxidation step. By this way, specific surface area values of carbon spheres of more than 1000 m2/g could be obtained. Best performing carbon materials (C#3) showed high adsorption capacity (e.g., 296 mg/g for methyl orange at solute equilibrium concentration of 24 mg/L in water). The XPS analysis revealed that only quaternary (N‐Q) and pyridinic (N‐6) nitrogen sites were found in these carbon spheres. The best ORR performance was found also for C#3 carbon spheres, with a potential of 0.81 V versus reversible hydrogen electrode (RHE) at −1 mA/cm2 and electron transfer number of 3.5 at 0.6–0.8 V versus RHE, as determined by rotating disk or rotating ring disk electrode tests. In conclusion, all results confirm that these PAN‐derived carbon spheres are potentially valuable materials for both wastewater treatment by adsorption and electrocatalytic oxygen reduction.
polymer science
What problem does this paper attempt to address?